The conversion of light to electrical and chemical energy has the potential to provide meaningful advances to many aspects of daily life, including the production of energy, water purification, and optical sensing. Recently, plasmonic nanoparticles (PNPs) have been increasingly used in artificial photosynthesis (e.g., water splitting) devices in order to extend the visible light utilization of semiconductors to light energies below their band gap. These nanoparticles absorb light and produce hot electrons and holes that can drive artificial photosynthesis reactions. For n-type semiconductor photoanodes decorated with PNPs, hot charge carriers are separated by a process called hot electron injection (HEI), where hot electrons with sufficient energy are transferred to the conduction band of the semiconductor. An important parameter that affects the HEI efficiency is the nanoparticle composition, since the hot electron energy is sensitive to the electronic band structure of the metal. Alloy PNPs are of particular importance for semiconductor/PNPs composites, because by changing the alloy composition their absorption spectra can be tuned to accurately extend the light absorption of the semiconductor. This work experimentally compares the HEI efficiency from Ag, Au, and Ag/Au alloy nanoparticles to TiO2 photoanodes for the photoproduction of hydrogen. Alloy PNPs not only exhibit tunable absorption but can also improve the stability and electronic and catalytic properties of the pure metal PNPs. In this work, we find that the Ag/Au alloy PNPs extend the stability of Ag in water to larger applied potentials while, at the same time, increasing the interband threshold energy of Au. This increasing of the interband energy of Au suppresses the visible-light-induced interband excitations, favoring intraband excitations that result in higher hot electron energies and HEI efficiencies.

Photoelectrochemical (PEC) water splitting is a promising technology that uses light absorbing semiconductors to convert solar energy directly into a chemical fuel (i.e., hydrogen). PEC water splitting has the potential to become a key technology in achieving a sustainable society, if high solar to fuel energy conversion efficiencies are obtained with earth abundant materials. This review article discusses recent developments and discoveries in the mechanisms by which the localized surface plasmon resonance (LSPR) in metallic nanoparticles can increase or complement a neighbouring semiconductor in light absorption for catalytic water splitting applications. These mechanisms can mitigate the intrinsic optical limitations of semiconductors (e.g., metal oxides) for efficient solar water splitting. We identify four types of enhancement mechanisms in the recent literature: (i) light scattering, (ii) light concentration, (iii) hot electron injection (HEI), and (iv) plasmon-induced resonance energy transfer (PIRET). (i) Light scattering and (ii) light concentration are light trapping mechanisms that can increase the absorption of light with energies above the semiconductor optical band-edge. These two mechanisms are ideal to enhance the absorption of promising semiconductors with narrow bandgap energies that suffer from limited absorption coefficients and bulk charge recombination. On the other hand, (iii) HEI and the recently discovered (iv) PIRET are mechanisms that can enhance the absorption also below the semiconductor optical band-edge. Therefore, HEI and PIRET have the potential to extend the light utilization to visible and near-infrared wavelengths of semiconductors with excellent electrochemical properties, but with large bandgap energies. New techniques and theories that have been developed to elucidate the above mentioned plasmonic mechanisms are presented and discussed for their application in metal oxide photoelectrodes. Finally, other plasmonic and non-plasmonic effects that do not increase the device absorption, but affect the electrochemical properties of the semiconductor (e.g., charge carrier transport) are also discussed, since a complete understanding of these phenomena is fundamental for the design of an efficient plasmonic NP-semiconductor water splitting device.

Funding Agencies|NWO (VENI project); Wenner-Gren Foundations; Swedish Research Council; Swedish Foundation for Strategic Research; Royal Swedish Academy of Sciences; AForsk Foundation; Swedish Government Strategic Research Area in Materials Science on Functional Materials at Linkoping University (Faculty Grant SFO-Mat-LiU) [2009 00971]

Au–Cu bimetallic thin films with controlled composition were fabricated by magnetron sputtering co-deposition, and their performance for the electrocatalytic reduction of CO2 was investigated. The uniform planar morphology served as a platform to evaluate the electronic effect isolated from morphological effects while minimizing geometric contributions. The catalytic selectivity and activity of Au–Cu alloys was found to be correlated with the variation of electronic structure that was varied with tunable composition. Notably, the d-band center gradually shifted away from the Fermi level with increasing Au atomic ratio, leading to a weakened binding energy of *CO, which is consistent with low CO coverage observed in CO stripping experiments. The decrease in the *CO binding strength results in the enhanced catalytic activity for CO formation with the increase in Au content. In addition, it was observed that copper oxide/hydroxide species are less stable on Au–Cu surfaces compared to those on the pure Cu surface, where the surface oxophilicity could be critical to tuning the binding strength of *OCHO. These results imply that the altered electronic structure could explain the decreased formation of HCOO– on the Au–Cu alloys. In general, the formation of CO and HCOO– as main CO2 reduction products on planar Au–Cu alloys followed the shift of the d-band center, which indicates that the electronic effect is the major governing factor for the electrocatalytic activity of CO2 reduction on Au–Cu bimetallic thin films.

The effect of plasmonic nanoparticles (NPs) on the photoelectrochemical water splitting performance of CuWO 4 is studied here for the first time. CuWO 4 thin films were functionalized with well-defined Au NPs in two composite configurations: with the NPs (I) at the CuWO 4 −electrolyte interface and (II) at the CuWO 4 back contact. In both cases, the incident photon to current conversion efficiency of the film was increased (∼6fold and ∼1.2-fold for configurations I and II (at λ = 390 nm), respectively). Two important advantages of placing the NPs on the CuWO 4 −electrolyte interface are identified: (1) Au NPs, coated with a 2 nm TiO 2 layer, are found to significantly enhance the surface catalysis of the film, decreasing the surface charge recombination from ∼60% to ∼10%, and (2) the NP's near-field can promote additional charge carriers within the space charge layer region, where they undergo field-assisted transport, essentially avoiding recombination. Our study shows that Au NPs, coated with a 2 nm TiO 2 layer, can significantly mitigate the catalytic and optical photoelectrochemical (PEC) limitations of CuWO 4 . An increase from 0.03 to 0.1 mA cm −2 in the water-splitting photocurrent was measured for a 200 nm film under simulated solar irradiation at 1.23 V vs RHE.

No abstract

CO 2 electroreduction is a promising technology to produce chemicals and fuels from renewable resources. Polycrystalline and nanostructured metals have been tested extensively while less effort has been spent on understanding the performance of bimetallic alloys. In this work, we study compositionally variant, smooth Au−Pd thin film alloys to discard any morphological or mesoscopic effect on the electrocatalytic performance. We find that the onset potential of CO formation exhibits a strong dependence on the Pd content of the alloys. Strikingly, palladium, a hydrogen evolution catalyst with reasonable exchange current density, suppresses hydrogen evolution when alloyed with gold in the presence of CO 2 . Cyclic voltammetry, in situ surface enhanced infrared absorption spectroscopy, and potential-dependent online product analysis strongly suggest that by alloying Au with Pd a significant increase in the surface coverage of adsorbed CO occurs with increasing Pd content at low overpotentials (e.g., approximately −0.35 V vs RHE). Such an increase in CO coverage suppresses H 2 evolution due to the lack of vacant active sites. Moreover, the overall increase in the binding energy with the CO 2 intermediates gained with the addition of Pd increases the CO production at low overpotentials, where polycrystalline Au suffers from poor CO 2 adsorption and poor selectivity for CO production. These results show that promising CO 2 reduction electrode materials (e.g., Au) can be alloyed not only to tune the catalyst's activity but also to deliberately decrease the availability of surface sites for competitive H 2 evolution.

The use of disc diffusion susceptibility tests to determine the antibacterial activity of engineered nanoparticles (ENPs) is questionable because their low diffusivity practically prevents them from penetrating through the culture media. In this study, we investigate the ability of such a test, namely the Kirby-Bauer disc diffusion test, to determine the antimicrobial activity of Au and Ag ENPs having diameters from 10 to 40 nm on Escherichia coli cultures. As anticipated, the tests did not show any antibacterial effects of Au nanoparticles (NPs) as a result of their negligible diffusivity through the culture media. Ag NPs on the other hand exhibited a strong antimicrobial activity that was independent of their size. Considering that Ag, in contrast to Au, dissolves upon oxidation and dilution in aqueous solutions, the apparent antibacterial behavior of Ag NPs is attributed to the ions they release. The Kirby-Bauer method, and other similar tests, can therefore be employed to probe the antimicrobial activity of ENPs related to their ability to release ions rather than to their unique size-dependent properties. Graphical abstractᅟ

Ag nanoparticles (NPs) are deposited on BiVO 4 photoanodes to study their effect on the photoelectrochemical (PEC) water splitting performance of the semiconductor. 15 nm light-absorbing NPs and 65 nm light scattering NPs were studied separately to compare their light trapping ability for enhancing the semiconductor's absorption through light concentration and light scattering, respectively. The 15 nm NPs enhanced the BiVO 4 external quantum efficiency throughout the semiconductor's absorption range (e.g., % 2.5 fold at l = 400 nm). However, when a hole scavenger was added to the electrolyte, no enhancement was observed upon NP deposition, indicating that the NPs only facilitate the injection of holes from the semiconductor surface to the electrolyte but do not enhance its absorption. On the other hand, the 65 nm scattering NPs not only facilitated hole injection to the electrolyte, but also enhanced the absorption of the semiconductor (by % 6 %) through light scattering. Such a dual effect, i.e., of enhancing both the surface properties and the absorption of the semiconductor, makes light scattering Ag NPs an ideal decoration for PEC water splitting photoelectrodes.The collective oscillation of valence electrons in metal nanoparticles (NPs) resulting from their electromagnetic interaction with light is known as surface plasmon resonance (SPR). As a result of this phenomenon, metal NPs can either absorb or scatter the irradiating light.[1] The photon frequencies in which the SPR takes place (i.e., the resonant frequencies) depend on the material, shape and size of the NPs.[1] Noble metal NPs (e.g., Ag and Au) exhibit resonance frequencies within the visible spectrum and are great candidate materials in solar energy conversion devices (e.g., photovoltaic and photocatalytic). [2][3][4][5][6] It has been shown that the incident energy absorbed by plasmonic NPs can be transferred to a nearby semiconducting photoelectrode, thereby enhancing its performance. [3][4][5][7][8][9] As a result, many noble metal NP/semiconductor systems have been studied to date, in particular to improve the rate of solar photoelectrochemical reactions (e.g., water splitting for hydrogen generation and phenol degradation for water purification). [4,8,[10][11][12][13][14][15][16][17] In many of these studies, the improvement of the semiconductor's performance, upon plasmonic NP functionalization, has been explained by a light trapping mechanism called local electromagnetic field enhancement or light concentration. In this mechanism, the SPR significantly enhances the intensity of the incoming electromagnetic field (e.g., solar radiation) in the vicinity of the NP, which locally increases the absorption in a nearby semiconductor. [3][4][5]7] Increasing the absorption in the vicinity of the NPs is advantageous when the NPs are placed at the semiconductor-electrolyte interface since, in this case, the absorption increase takes place in the semiconductor space-charge layer where the electron-hole pairs are more efficiently separated. In...