This study seeks to investigate the concept of using large waste rocks from mining operations as waste-heat thermal energy storage for remote arctic communities, both commercial and residential. It holds its novelty in analyzing such systems with an experimentally validated transient three-dimensional computational fluid dynamics and heat transfer model that accounts for interphase energy balance using a local thermal non-equilibrium approach. The system performance is evaluated for a wide range of distinct parameters, such as porosity between 0.2 and 0.5, fluid velocity from 0.01 to 0.07 m/s, and the aspect ratio of the bed between 1 and 1.35. It is demonstrated that the mass flow rate of the heat transfer fluid does not expressively impact the total energy storage capacity of the rock mass, but it does significantly affect the charge/discharge times. Finally, it is shown that porosity has the greatest impact on both fluid flow and heat transfer. The evaluations show that about 540 GJ can be stored on the bed with a porosity of 0.2, and about 350 GJ on the one with 0.35, while the intermediate porosity leads to a total of 450 GJ. Additionally, thermal capacity is deemed to be the most important thermophysical factor in thermal energy storage performance.
Remote communities that have limited or no access to the power grid commonly employ diesel generators for communal electricity provision. Nearly 65% of the overall thermal energy input of diesel generators is wasted through exhaust and other mechanical components such as water-jackets, intercoolers, aftercoolers, and friction. If recovered, this waste heat could help address the energy demands of such communities. A viable solution would be to recover this heat and use it for direct heating applications, as conversion to mechanical power comes with significant efficiency losses. Despite a few examples of waste heat recovery from water-jackets during winter, this valuable thermal energy is often discarded into the atmosphere during the summer season. However, seasonal thermal energy storage techniques can mitigate this issue with reliable performance. Storing the recovered heat from diesel generators during low heat demand periods and reusing it when the demand peaks can be a promising alternative. At this point, seasonal thermal storage in shallow geothermal reserves can be an economically feasible method. This paper proposes the novel concept of coupling the heat recovery unit of diesel generators to a borehole seasonal thermal storage system to store discarded heat during summer and provide upgraded heat when required during the winter season on a cold, remote Canadian community. The performance of the proposed ground-coupled thermal storage system is investigated by developing a Computational Fluid Dynamics and Heat Transfer model.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.