This paper presents the results of numerical investigations into the behavior of a sinusoidal web loaded in shear due to buckling in the period from the onset of buckling until failure, as well as the impact of a reinforced concrete slab on the stability of the web. The analysis concerned steel girders and composite girders with the top flange bonded to a reinforced concrete slab. Nonlinear analyses were performed using the finite element method. The results of the investigations support the conclusion that the appearance and propagation of shear stresses in the sinusoidal web of the composite steel–concrete beam are the same as those in an identical non-composite steel beam, but the bracing of the top flanges improves the shear strength and, at the same time, affects the location of initial stresses. In addition, it was found that, despite the three types of buckling, the predominant failure of the sinusoidal webs, regardless of the presence of the concrete slab, is global buckling. It occurs diagonally through several folds at the same time, including deformation of the web over its entire height.

Until recently, steel plate girders with corrugated steel members were used primarily as poles and girders in the construction of industrial buildings. Currently, they are also being used in the construction of bridges. Compared to traditional steel and rolled girders, steel plate girders weigh less and are more stiff, while also having a neater appearance. In this paper, the results of an experimental study are present. The aim of the study was to determine the behavior of a bridge girder with sinusoidal web geometry when subjected to a bending moment. The study was focused on a composite steel and concrete structure with pin connections, which is currently the most common solution. Three near-real scale beams were subjected to bending tests. The study found that composite corrugated-web steel beams and non-composite corrugated-web steel beams showed similar forms of failure. A reinforced concrete slab did not prevent web stress concentration at the point of connection with the flange. Furthermore, the study indicates that corrugated steel webs in bridge girders can have a much smaller thickness (less than 8 mm) compared with the traditional solution.

Thin-walled structures are commonly used as energy absorbers in motor vehicles. Their function is to protect the structural components of vehicles and to absorb energy completely during collisions up to 20 km/h. This paper focuses on maintaining crush axiality during research. To verify the numerical analyses, physical specimens were made and then subjected to dynamic crushing. Force and shortening values as well as high-speed camera images were used for data analysis. Through time-lapse shots, plastic deformation within the crush initiator was observed. Such detailed analysis allowed the determination of the influence of hexagonal triggers in the form of notches on the post-buckling progressive analysis. In this paper, neural networks were used to examine the importance of each variable. Data from numerical analyses were used for this purpose. Based on the analyses performed, the effects of both the width and height of the triggers on the crush load efficiency (CLE) and total efficiency (TE) ratios can be seen. The width of the crush initiator has the greatest influence on Crash-box performance. Nevertheless, increasing both the height and the width of the initiator can result in crush non-axiality and underperformance of the energy absorber.

This paper presents the results of experimental investigations performed on beams with corrugated webs. The aim of the research was to determine the effect of the geometric parameters of the sinusoidal web on the behavior of I-beams subjected to four-point bending. Special attention was paid to the effects of web thickness and wave geometry on the deflection of beams. The obtained failure modes of particular test samples are presented. Reference has also been made to the determined standard load capacities based on Annex D of the EC3 standard. In order to compare the performance of beams with corrugated webs, the results for beams with flat webs of the same thickness of web sheets are also presented.

No abstract