No abstract

No abstract

A detailed picture of the thermally activated processes occurring at the Co/ZnO interface is obtained by a combination of high energy X-ray based techniques: X-ray photoelectron and absorption spectroscopies and the kinematical X-ray standing wave method. At room temperature, the growth of a few monolayers of cobalt proceeds by the nucleation of nanometer-sized clusters on the polar oxygen-terminated (0001̅) surface of a ZnO single crystal. Progressive annealing from 600 to 970 K allows separating the various interfacial reactions. At the lowest annealing temperature, Co clusters coalesce while keeping their metallic character. Above 700 K Co0 is gradually oxidized to Co2+ and a thin Co rich (Zn,Co)O layer is formed. It is observed that rock salt CoO phases may form at the surface when the initial Co thickness exceeds 1 nm. At the highest annealing temperature (970 K), Co diffuses deeper into ZnO and Zn vacancies are created at subsurface sites that were previously occupied by Co.

A novel approach for Ta and Nb extraction consisting of the pre-treatment of a coltan-bearing ore with an ammonium bifluoride sub-molten salt and subsequent acid leaching has been studied. The effects from ore granulometry, ammonium bifluoride (ABF) to ore mass ratio, temperature and duration of fluorination on the degree of Ta and Nb extraction were examined. The ABF to ore ratio and process temperature were found to have the most pronounced impact on extraction efficiency. The following optimal process conditions were determined: ore granulometric fraction (−75 + 45 µm), ABF-ore (5/1), fluorination temperature (200 °C) and fluorination time (2.5 h). Maintaining these parameters enabled about 94% of Ta and 95% of Nb to be brought into solution during the sulfuric-acid-leaching stage. A comparison of the proposed method with previously reported studies suggests that due to the effects of mechanical agitation and the recirculation of the HF-containing gaseous phase back into the process, the dosage rate of ABF at the fluorination stage could be reduced significantly without sacrificing the overall recovery of Ta and Nb. In such a way, the approach could offer added environmental benefits since release of fluoride-containing effluents into the environment could be limited.