The structure and kinetics of fibrin gels grown from fibrinogen solutions under quasiphysiological conditions, but in absence of Ca++, were investigated by means of elastic light scattering. By combining classical light scattering and low-angle elastic light scattering, an overall wave-vector range of about three decades was spanned, from q approximately 3 x 10(2) to q approximately 3 x 10(5) cm(-1). The scattered intensity distribution of the gels was measured in absolute units and fitted to a single function, which was able to reproduce accurately the data over the entire wave-vector range. From the fitting, it was possible to estimate the average diameter d of the fibrin fibers, the average crossover length xi of the gel, and establish the fractal nature of the gel structure, with a measure of its fractal dimension D(m). The measure of the intensity in absolute units also allowed the estimate of the density rho of the fibrin fibers and provided an independent measure of their size. The kinetics of formation of the gel was described in terms of a simple growth model: the scaffold of the network is formed very early in the course of the gelation process, at a "networking time," t(n), which is much smaller than the time required to form the final gel. At times t>t(n), the gel structure remains substantially unchanged and the successive growth consists only in a thickening of the gel fibers. Gels prepared under the same physical-chemical conditions, but at different fibrinogen concentrations, exhibited rather similar structures and kinetics, showing that the modalities of the gelation process are mainly governed by the solution conditions, and only secondarily by the fibrinogen concentration. For gels at fibrinogen concentration of approximately 0.24 mg/ml, the gel parameters were d approximately 130 nm, xi approximately 27 microm, D(m) approximately 1.3, and rho approximately 0.4 g/cm(3). Our d and rho values are in very good agreement with electron microscopy- and turbidity-derived literature data, respectively, while xi seems to be related to the mesh size of the initial scaffold formed at t(n), rather than to the mesh size of the final aged gel.

No abstract

Recent advancements in bidimensional nanoparticles production such as Graphene (G) and Graphene oxide (GO) have the potential to meet the need for highly functional personal protective equipment (PPE) against SARS-CoV-2 infection. The ability of G and GO to interact with microorganisms provides an opportunity to develop engineered textiles for use in PPE and limit the spread of COVID-19. PPE in current use in high-risk settings for COVID transmission provide only a physical barrier that decreases infection likelihood and does not inactivate the virus. Here, we show that virus pre-incubation with soluble GO inhibits SARS-CoV-2 infection of VERO cells. Furthermore, when G/GO functionalized polyurethane or cotton were in contact SARS-CoV-2, the infectivity of the fabric was nearly completely inhibited. The findings presented here constitute an important innovative nanomaterial-based strategy to significantly increase PPE efficacy in protection against the SARS-CoV-2 virus that may implement water filtration, air purification, and diagnostics methods.

No abstract

Varactor diode-based circuit topologies, which can act as high-Q "distortion-free" tunable capacitive elements, are presented. These diodes are implemented in a novel ultra low-loss silicon-on-glass technology, with resulting measured Q's of over 200 at 2 GHz. The measured IM3 improvement compared to traditional single varactor tuning techniques is greater than 30 dB.

Recent evidence has shown that graphene quantum dots (GQDs) are capable of crossing the blood–brain barrier, the barrier that reduces cancer therapy efficacy. Here, we tested three alternative GQDs’ surface chemistries on two neural lineages (glioblastoma cells and mouse cortical neurons). We showed that surface chemistry modulates GQDs’ biocompatibility. When used in combination with the chemotherapeutic drug doxorubicin, GDQs exerted a synergistic effect on tumor cells, but not on neurons. This appears to be mediated by the modification of membrane permeability induced by the surface of GQDs. Our findings highlight that GQDs can be adopted as a suitable delivery and therapeutic strategy for the treatment of glioblastoma, by both directly destabilizing the cell membrane and indirectly increasing the efficacy of chemotherapeutic drugs.

No abstract

In this paper we demonstrate, at 300 GHz and with integrated technology, the effectiveness of artificial dielectric layers to enhance the front-to-back ratio of printed antennas. This concept was previously proposed at microwave frequencies and using printed circuit board technology. The artificial material is now realized by introducing non-resonant metallic inclusions in a silicon dioxide host material. This allows to enhance the permittivity of the host medium and renders it anisotropic. By loading an electrically thin dielectric with these metallic inclusions, an engineered slab with effectively quarter wavelength thickness has been realized. Despite the large effective height and density of the artificial dielectric, the surface wave efficiency of the antenna is 99%. This is entirely due to the anisotropic properties of the material. A prototype antenna was built using an inhouse complementary metal-oxide semiconductor (CMOS) backend compatible integrated circuits (IC) process. Measured results from the antenna are presented and show a good agreement with the expected results.