A: European Spallation Source (ESS) will deliver neutrons at high flux for use in diverse neutron scattering techniques. The neutron source facility and the scientific instruments will be located in Lund, and the Data Management and Software Centre (DMSC), in Copenhagen. A number of detector prototypes are being developed at ESS together with its European in-kind partners, for example: SoNDe, Multi-Grid, Multi-Blade and Gd-GEM. These are all position sensitive detectors but use different techniques for the detection of neutrons. Except for digitization of electronics readout, all neutron data is anticipated to be processed in software. This provides maximum flexibility and adaptability and allows deep inspection of the raw data for commissioning which will reduce the risk of starting up new detector technologies. But it also requires development of high performance software processing pipelines and optimized and scalable processing algorithms. This report provides a description of the ESS system architecture for the neutron data path. Special focus is on the interface between the detectors and DMSC which is based on UDP over Ethernet links. The report also describes the software architecture for detector data processing and the tools we have developed, which have proven very useful for efficient early experimentation, and can be run on a single laptop. Processing requirements for the SoNDe, Multi-Grid, Multi-Blade and Ge-GEM detectors are presented and compared to event processing rates archived so far.

No abstract

A: The European Spallation Source (ESS) will provide long neutron pulses for experiments on a suite of different instruments. Most of these will perform neutron data acquisition in event mode, i.e. each detected neutron will be characterised by one absolute timestamp and pixel identifier pair. Slow controls metadata from EPICS, such as sample environment measurements and motor positions, will also be timestamped at their source, so that all data and metadata are streamed as a list of events instead of histograms. A flexible data aggregation and streaming system is being developed combining both open source third-party software and in-house development. This is to be used at ESS and other neutron scattering facilities like ISIS and SINQ, replacing legacy solutions by a shared software collection maintained by a cross-facility effort. The architecture of the Apache Kafka-based system, its metadata forwarding and NeXus file writing components are presented, along with test results demonstrating their integration and the scalability in terms of performance.

The boron-10 based Multi-Grid detector is being developed as an alternative to helium-3 based neutron detectors. At the European Spallation Source, the detector will be used for time-of-flight neutron spectroscopy at cold to thermal neutron energies. The objective of this work is to investigate fine time-and energyresolved effects of the Multi-Grid detector, down to a few µeV, while comparing it to the performance of a typical helium-3 tube. Furthermore, it is to characterize differences between the detector technologies in terms of internal scattering, as well as the time reconstruction of ∼ µs short neutron pulses. The data were taken at the Helmholtz Zentrum Berlin, where the Multi-Grid detector and a helium-3 tube were installed at the ESS test beamline, V20. Using a Fermi-chopper, the neutron beam of the reactor was chopped into a few tens of µs wide pulses before reaching the detector, located a few tens of cm downstream. The data of the measurements show an agreement between the derived and calculated neutron detection efficiency curve. The data also provide fine details on the effect of internal scattering, and how it can be reduced. For the first time, the chopper resolution was comparable to the timing resolution of the Multi-Grid detector. This allowed a detailed study of time-and energy resolved effects, as well as a comparison with a typical helium-3 tube.

A new γγ coincidence system has been set up at NIST. It is operated with a digital data finder supported by new software developed at NIST. The system is used to explore possible enhancements in instrumental neutron activation analysis (INAA) and study applicability to neutron capture prompt gamma activation analysis (PGAA). The performance of the system is tested with certified reference materials for efficiency calibration and quantitative performance. Comparisons of INAA results based on conventional gamma-ray spectrometry data with INAA results based on coincidence data obtained from the same samples show improvements in the counting uncertainties and demonstrates the quantitative accuracy of the new system.

No abstract

Coincidence counting in neutron activation analysis has well-known advantages, most importantly improvement of detection limits. One obstacle to the wider use of this technique is the complexity of the data acquisition and reduction systems that it requires. The usual approaches to multi-detector data acquisition incur significant dead-time, involve redundant work in repeatedly developing limited tools and risk potential errors in low-level code. The paper describes progress made in developing a software framework to address these shortcomings.

No abstract