Jute cellulose composite (JCC), bamboo cellulose composite (BCC), untreated hybrid jute-bamboo fiber composite (UJBC), and jute-bamboo cellulose hybrid biocomposite (JBCC) were fabricated. All cellulose hybrid composites were fabricated with chemical treated jute-bamboo cellulose fiber at 1 : 1 weight ratio and low-density polyethylene (LDPE). The effect of chemical treatment and fiber loading on the thermal, mechanical, and morphological properties of composites was investigated. Treated jute and bamboo cellulose were characterized by Fourier transform infrared spectroscopy (FTIR) to confirm the effectiveness of treatment. All composites were characterized by tensile testing, thermogravimetric analysis (TGA), and differential scanning calorimetry (DSC). Additionally, surface morphology and water absorption test was reported. The FTIR results revealed that jute and bamboo cellulose prepared are identical to commercial cellulose. The tensile strength and Young's modulus of composites are optimum at 10 weight percentage (wt%) fibers loading. All cellulose composites showed high onset decomposition temperature. At 10 wt% fiber loading, JBCC shows highest activation energy followed by BCC and JCC. Significant reduction in crystallinity index was shown by BCC which reduced by 14%. JBCC shows the lowest water absorption up to 43 times lower compared to UJBC. The significant improved mechanical and morphological properties of treated cellulose hybrid composites are further supported by SEM images.

No abstract

No abstract

Centella asiatica (C. Asiatica) is a traditional herb that has been used in raditional medicine especially in Asia region. Recently the pharmalogical study of Asiatic acid (AA) which is one of bioactive constituents in C. Asiatica has been studied and revealed that this compound has a potential to be use in medicine area. The objective of this paper is to produce nanoparticles C. Asiatica by Planetary Ball Mill (PBM) and determined the effect of nanonization on extraction yield of asiatic acid. The particles were analyzed using particle sizer to determine size of particle produce and the morphology was evaluated through FESEM. As a result, the mean particles size of nanopowders was 501.10 nm and the extraction of asiatic acid using nanopowders showed 82.09 % higher than original powder.

No abstract

No abstract

No abstract

New market trend for organic solar cell (OSC) require lightweight, cost effective, environmentally friendly and flexible. Transparent conductive electrode (TCE) is a main building block in organic solar cell in determining the device performance. Indium tin oxide (ITO) is widely used as transparent conductive material however it has major drawbacks due to relatively expensive, brittle and it limited to use on flexible substrate. This paper provides a short review of the transparent conductive electrode material which required for OSC applications. Issues related with existing TCE material such as ITO is also highlighted. Thus, alternative green material resources which offer low cost, environmentally friendly, mechanically robust and low sheet resistances are strongly required. Graphene is suitable candidate due to their outstanding properties such as good electrical, green material, chemical and thermally stable as well as remarkable mechanical strength and flexibility. The performance of transparent graphene electrode using low cost fabrication method which related with electrical, optical and power conversion efficiency was reviewed. We believed this work will provide beneficial input toward the improvement of OSC device performance.