No abstract

No abstract

No abstract

No abstract

Pyrolysis has the potential of transforming used tyres into useful recyclable products. Pyrolytic carbon black is one of the most important products of tyre pyrolysis. Waste tyres were pyrolysed at 450°C in a batch reactor under atmospheric pressure. The recovered pyrolytic carbon black residues were studied to investigate their characteristics for use as a possible adsorbent. EDX elemental analysis and surface area determinations were used to investigate the distinctive features of pyrolytic carbon black. Due to various inorganic additives of the original tyre that contaminated the carbon black obtained, it was treated with acid for demineralization. The demineralized carbon black was activated at 900°C in a furnace. It was observed that acid treatment and activation increased the surface areas and decreased the concentration of contaminants. Furthermore, adsorption characteristics of methylene blue on acid-treated and activated carbon black (prepared via acid treatment) were compared with those of commercial activated carbon in liquid phase adsorption. It was found that adsorption capacity of methylene blue on acid-treated activated carbon black was greater.

A simple, sensitive and accurate method has been developed for spectrofluorimetric determination of cefixime in pure form and pharmaceutical preparations. The method is based on the reaction of cefixime with 2-cyanoacetamide in the presence of 21% ammonia at 100 °C. The fluorescent reaction product showed maximum fluorescence intensity at λ 378 nm after excitation at λ 330 nm. The factors affecting the derivatization reaction were carefully studied and optimized. The fluorescence intensity versus concentration plot was rectilinear over the range of 0.02 to 4 μg mL(-1) with correlation coefficient of 0.99036. The limit of detection (LOD) and limit of quantification (LOQ) was found to be 2.95 ng mL(-1) and 9.84 ng mL(-1), respectively. The proposed method was validated statistically and through recovery studies. The method was successfully applied for the determination of cefixime in pure and dosage form with percent recoveries from 98.117% to 100.38%. The results obtained from the proposed method have been compared with the official HPLC method and good agreement was found between them.

No abstract

No abstract