Recently Franken et al. ' demonstrated the gen-

Effects of rf bias on the superconducting and structural properties of rf magnetron sputtered NbN J. Appl. Phys. 59, 2905 (1986); 10.1063/1.336950 rf superconducting properties of reactively sputtered NbN

Multi-loop arrays of Josephson junctions (JJs) with non-uniform area distributions, which are known as superconducting quantum interference filters (SQIFs), are the most highly sensitive sensors of changes in applied magnetic field as well as the absolute magnitude of magnetic fields. The non-uniformity of the loop sizes allows the array to produce a unique collective voltage response that has a pronounced single peak with a large voltage swing around zero magnetic field. To obtain high linear dynamic range, which is critical for a wide variety of applications, the linearity of the slope of the anti-peak response must be improved. We propose a novel scheme for enhancing linearity—a new configuration combining the SQIF array concept with the recently introduced bi-superconductive quantum interference device (SQUID) configuration, in which each individual SQUID loop is made up of three JJs as opposed to using two JJs per loop in standard dc SQUIDs. We show, computationally, that the additional junction offers a viable linearization method for optimizing the voltage response and dynamic range of SQIF arrays. We have realized SQIF arrays based on bi-SQUID cells and present first experimental results.

SQUID arrays are promising candidates for low profile antennas and low noise amplifier applications. We present the integrated circuit designs and results of DC and RF measurements of the wideband serial arrays based on integration of linear bi-SQUID cells forming a Superconducting Quantum Interference Filter (bi-SQUID SQIF). Various configurations of serial arrays designs are described. The measured linearity, power gain, and noise temperature are analyzed and compared. The experimental results are matched to results of mathematical modeling. A serial bi-SQUID SQIF arrays are mounted into a coplanar waveguide (CPW) and symmetrically grounded to corresponding sides of CPW. The RF output comes out from the central common line, which is also used for DC biasing and forms a symmetrical balanced output. The signal and DC flux biasing line is designed as coplanar lines passed in parallel over each bi-SQUID cell in a bidirectional fashion concentrating magnetic flux inside of each cell. Serial bi-SQUID SQIF arrays are fabricated on 5 mm x 5 mm chips using standard HYPRES niobium 4.5 kA/cm 2 fabrication process.Index Terms-noise temperature, broadband, electrically small antenna, low noise amplifier, high sensitivity, high linearity

No abstract