By tailoring the boundary of a narrow semiconductor channel to break its symmetry, we have realized a type of nanometer-scale nonlinear device, which we refer to as self-switching device (SSD). An applied voltage V not only changes the potential profile along the channel direction, but also either widens or narrows the effective channel depending on the sign of V. This results in a diode-like characteristic but without the use of any doping junction or barrier structure. The turn-on voltage can also be widely tuned from virtually zero to more than 10 V, by simply adjusting the channel width. The planar and two-terminal structure of the SSD also allows SSD-based circuits to be realized by only one step of lithography.

No abstract

We demonstrate the critical effect of postgrowth annealing temperature on the properties of low-temperature-grown GaAs. By using annealing temperatures substantially below the 500–600 °C commonly reported, GaAs with high resistivity and with carrier lifetimes as short as 100 fs can be routinely obtained. We discuss the optimum, but different, anneal conditions required for terahertz photoconductive emitters and detectors, and illustrate their use in a continuous-wave system.

By using arrays of nanowires with intentionally broken symmetry, we were able to detect microwaves up to 110 GHz at room temperature. This is, to the best of our knowledge, the highest speed that has been demonstrated in different types of novel electronic nanostructures to date. Our experiments showed a rather stable detection sensitivity over a broad frequency range from 100 MHz to 110 GHz. The novel working principle enabled the nanowires to detect microwaves efficiently without a dc bias. In principle, the need for only one high-resolution lithography step and the planar architecture allow an arbitrary number of nanowires to be made by folding a linear array as many times as required over a large area, for example, a whole wafer. Our experiment on 18 parallel nanowires showed a sensitivity of approximately 75 mV dc output/mW of nominal input power of the 110 GHz signal, even though only about 0.4% of the rf power was effectively applied to the structure because of an impedance mismatch. Because this array of nanowires operates simultaneously, low detection noise was achieved, allowing us to detect -25 dBm 110 GHz microwaves at zero bias with a standard setup.