Analyses of sonic logs in a horizontal well provide new information about mechanical properties of rocks, made possible by recent developments in our understanding of acoustic wave propagation in prestressed formations. Most sections of this horizontal well exhibit azimuthal shear isotropy, indicating isotropic stresses in the plane perpendicular to the well trajectory, leading to stable wellbore conditions. However, two sections show dipole dispersion crossovers that confirm the presence of stress‐induced shear anisotropy caused by a difference between the maximum and minimum stresses in the plane perpendicular to the well trajectory. The two dipole dispersions are obtained by processing the recorded waveforms by a modified matrix pencil algorithm. The fast‐shear direction is estimated from Alford rotation of the cross‐dipole waveforms. One section of the well exhibits the fast‐shear direction parallel to the overburden stress as the maximum stress direction, whereas the other section has the fast‐shear direction parallel to the horizontal stress that is larger than the overburden stress. The cause of this change in the fast‐shear direction is believed to be the well’s penetration into a 3-ft-thick bed with lower porosity and permeability and significantly higher elastic stiffnesses than those in the other part of the homogeneous, high‐permeability reservoir. A stiff bed is likely to have greater stresses in its plane than perpendicular to it, which would make the horizontal stresses greater than the vertical.
Within the Corinth Rift Laboratory, dipole sonic data have been acquired in the AIG 10 well between depths 711 and 1004 m during three passes of a sonic logging tool at three different borehole fluid pressures. Specific sections of the well reveal clear characteristics of either moderate-to-large azimuthal anisotropy (9-25%) below the Aigion Fault, e.g., 779-784 and 809-816 m, with a fast-shear azimuth directed 105 • , or homogeneous isotropic medium (i.e., 735-753 m) between the casing shoe and the fault. The presence of the fault is coincident with the identification of lower velocities over an interval of approximately 12-14 m. Analysis of the data reveals that the formation is not acoustically stress-sensitive to the 3 MPa differential pressure applied. Interpretation of the sonic data with complementary image logs suggests the anisotropy is due to intrinsic fractures and bedding, and the fast-shear direction 105 • is consistent with the regional maximum horizontal stress.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.