No abstract

Detection of chromosomal aneuploidies using fetal cells isolated from maternal blood, for prenatal non-invasive genetic investigation, has been a long-sought goal of clinical genetics to replace amniocentesis and chorionic villous sampling to avoid any risk to the fetus. The purpose of this study was to develop a sensitive and specific new assay for diagnosing aneuploidy with circulating fetal cells isolated from maternal blood as previously reported using two novel approaches: (i) simultaneous immunocytochemistry (ICC) evaluation using a monoclonal antibody for i-antigen, followed by fluorescence in situ hybridization (FISH); (ii) dual-probe FISH analysis of interphase nuclei using two differently labeled probes, specific for different loci of chromosomes 21 and 18; in addition, short tandem repeats (STR) analysis on single cells isolated by micromanipulation was applied to confirm the presence of fetal cells in the cell sample enriched from maternal blood. Blood samples were obtained from women carrying trisomic fetuses, and from non-pregnant women and men as controls. Using ICC-FISH approach, a large heterogeneity in immunostaining pattern was observed, which is a source of very subjective signal interpretation. Differently, dual-probe FISH analysis provided for a correct diagnosis of all pregnancies: the mean percentage of trisomic cells was 0.5% (range, 0.36-0.76%), while the mean percentage of trisomic cells in the control group (normal pregnancies or non-pregnant women) was ≤0.20%. The application of the dual-probe FISH protocol on fetal cells isolated from maternal blood enables accurate molecular detection of fetal aneuploidy, thus providing a foundation for development of non-invasive prenatal diagnostic testing.

Ti6Al4V alloy is still attracting great interest because of its application as an implant material for hard tissue repair. This research aims to produce and investigate in-situ chitosan/hydroxyapatite (CS/HA) nanocomposite coatings based on different amounts of HA (10, 50 and 60 wt.%) on alkali-treated Ti6Al4V substrate through the sol-gel process to enhance in vitro bioactivity. The influence of different contents of HA on the morphology, contact angle, roughness, adhesion strength, and in vitro bioactivity of the CS/HA coatings was studied. Results confirmed that, with increasing the HA content, the surface morphology of crack-free CS/HA coatings changed for nucleation modification and HA nanocrystals growth, and consequently, the surface roughness of the coatings increased. Furthermore, the bioactivity of the CS/HA nanocomposite coatings enhanced bone-like apatite layer formation on the material surface with increasing HA content. Moreover, CS/HA nanocomposite coatings were biocompatible and, in particular, CS/10 wt.% HA composition significantly promoted human mesenchymal stem cells (hMSCs) proliferation. In particular, these results demonstrate that the treatment strategy used during the bioprocess was able to improve in vitro properties enough to meet the clinical performance. Indeed, it is predicted that the dense and crack-free CS/HA nanocomposite coatings suggest good potential application as dental implants.

No abstract

No abstract