Epitaxial layers were grown on semi-insulating LEC GaAs substrates by the chloride CVD technique and depletion type MESFET's with a gate length of 0.5 am have been fabricated on these epitaxial layers. Correlation between the FET device performance and the substrate quality has been studied. It was found that the substrate quality largely affects the device performance. Dislocations of the substrate had no definite effect on the device performance, while the density of the precipitate-like microscopic defects revealed by AB solution had a decisive effect on the device performance and the uniformity. We have examined LEC GaAs substrates with various density of etch pits revealed by AB solution (AB-EPD) but with nearly the same order of dislocation density revealed by KOH etching. The AB-EPD ranged from less than 104 to 5 • 105 cm 2, while the average dislocation density was in the range of 1-3 z 10 4 cm -2. The standard deviation of the gm compression over 2 in. ~ wafers was very small in the case of low AB-EPD wafers, while it was very large in the case of high AB-EPD wafers. When the substrate with FETs was etched by AB solution after the device performance measurement, it became evident that FETs with several AB etch pits under the gate area exhibited lower performance. It was also found that the photoluminescence intensity and its distribution over the substrate corresponded with the etch pit pattern generated by the AB solution.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.