Centre d'études et d'expertise sur les risques, l'environnement, la mobilité et l'aménagement

No abstract

No abstract

No abstract

The SwissFEL X-ray Free Electron Laser (XFEL) facility started construction at the Paul Scherrer Institute (Villigen, Switzerland) in 2013 and will be ready to accept its first users in 2018 on the Aramis hard X-ray branch. In the following sections we will summarize the various aspects of the project, including the design of the soft and hard X-ray branches of the accelerator, the results of SwissFEL performance simulations, details of the photon beamlines and experimental stations, and our first commissioning results.

No abstract

The emittance of the electron beam is crucial for Free-Electron Laser facilities: it has a strong influence on the lasing performance and on the total length of the accelerator. We present our procedure to measure and minimize the projected and slice emittance at the SwissFEL Injector Test Facility. The normalized slice emittance resolution achieved is about 3 nm and the longitudinal resolution is about 13 fs, with measurement errors estimated to be below 5%. After performing a full optimization we have obtained, for uncompressed beams, a slice emittance of about 200 nm for a beam charge of 200 pC, and a slice emittance of about 100 nm for 10 pC. These values are consistent with our simulations and are well below the requirements of the SwissFEL under construction at the Paul Scherrer Institute. At these bunch charges our measured slice emittances are, to our knowledge, the lowest reported so far for an electron linear accelerator.

A beam optics scheme has been designed for the Future Circular Collider-e + e − (FCC-ee). The main characteristics of the design are: beam energy 45 to 175 GeV, 100 km circumference with two interaction points (IPs) per ring, horizontal crossing angle of 30 mrad at the IP and the crab-waist scheme [1] with local chromaticity correction. The crab-waist scheme is implemented within the local chromaticity correction system without additional sextupoles, by reducing the strength of one of the two sextupoles for vertical chromatic correction at each side of the IP. So-called "tapering" of the magnets is applied, which scales all fields of the magnets according to the local beam energy to compensate for the effect of synchrotron radiation (SR) loss along the ring. An asymmetric layout near the interaction region reduces the critical energy of SR photons on the incoming side of the IP to values below 100 keV, while matching the geometry to the beam line of the FCC proton collider (FCC-hh) [2] as closely as possible. Sufficient transverse/longitudinal dynamic aperture (DA) has been obtained, including major dynamical effects, to assure an adequate beam lifetime in the presence of beamstrahlung and top-up injection. In particular, a momentum acceptance larger than ±2% has been obtained, which is better than the momentum acceptance of typical collider rings by about a factor of 2. The effects of the detector solenoids including their compensation elements are taken into account as well as synchrotron radiation in all magnets.The optics presented in this paper is a step toward a full conceptual design for the collider. A number of issues have been identified for further study.