No abstract

All 3 fixation devices (LISS, ABP, and IMN) offer sufficient torsional stability and sufficient proximal fixation that withstands axial loading without failing. The LISS provides improved distal fixation, especially in osteoporotic bone, at the expense of more displacement at the fracture site.

This study evaluated a porous tantalum biomaterial (Hedrocel) designed to function as a scaffold for osseous ingrowth. Samples were characterized for structure, Vickers microhardness, compressive cantilever bending, and tensile properties, as well as compressive and cantilever bending fatigue. The structure consisted of regularly arranged cells having struts with a vitreous carbon core with layers of CVI deposited crystalline tantalum. Microhardness values ranged from 240-393, compressive strength was 60 +/- 18 MPa, tensile strength was 63 +/- 6 MPa, and bending strength was 110 +/- 14 MPa. The compressive fatigue endurance limit was 23 MPa at 5 x 10(6) cycles with samples exhibiting significant plastic deformation. SEM examination showed cracking at strut junctions 45 degrees to the axis of the applied load. The cantilever bending fatigue endurance limit was 35 MPa at 5 x 10(6) cycles, and SEM examination showed failure due to cracking of the struts on the tension side of the sample. While properties were variable due to morphology, results indicate that the material provides structural support while bone ingrowth is occurring. These findings, coupled with the superior biocompatibility of tantalum, makes the material a candidate for a number of clinical applications and warrants further and continued laboratory and clinical investigation.

No abstract

Despite unicortical fixation axial loading to failure of the LISS did not result in implant/screw pull-out neither proximally nor distally. However, there does not appear to be a biomechanical advantage of using the LISS as opposed to a blade plate in bones with high bone mineral density.

No abstract

Wear of the polyethylene in total joint prostheses has been a source of morbidity and early device failure, which has been extensively reported in the last 20 years. Although research continues to attempt to reduce the wear of polyethylene joint-bearing surfaces by modifications in polymer processing, there is a renewed interest in the use of metal-on-metal bearing couples for hip prostheses. Wear testing of total hip replacement systems involving the couple of metal or ceramic heads on polymeric acetabular components has been performed and reported, but, until recently, there has been little data published for pin-on-disk or hip-simulator wear studies involving the combination of a metallic femoral head component with an acetabular cup composed of the same or a dissimilar metal. This study investigated the in vitro wear resistance of two cobalt/chromium/molybdenum alloys, which differed primarily in the carbon content, as potential alloys for use in a metal-on-metal hip-bearing couple. The results of pin-on-disk testing showed that the alloy with the higher (0.25%) carbon content was more wear resistant, and this alloy was therefore chosen for testing in a hip-simulator system, which modeled the loads and motions that might be exerted clinically. Comparison of the results of metal-on-polyethylene samples to metal-on-metal samples showed that the volumetric wear of the metal-on-polyethylene bearing couple after 5,000,000 cycles was 110 -180 times that for the metal-bearing couple. Polyethylene and metal particles retrieved from either the lubricant for pin-on-disk testing or hip simulator testing were characterized and compared with particles retrieved from periprosthetic tissues by other researchers, and found to be similar. Based upon the results of this study, metal-on-metal hip prostheses manufactured from the high carbon cobalt/chromium alloy that was investigated hold sufficient promise to justify human clinical trials.

No abstract