ResumenA partir de datos de velocidad de corrosión atmosférica y variables ambientales en diferentes sitios de Costa Rica, se realizan evaluaciones matemáticas de los modelos usuales utilizados para la estimación de la velocidad de corrosión (Vcorr). Estos datos de contaminantes y parámetros atmosféricos en conjunto con la velocidad de corrosión obtenida gravimétricamente, son modelados por medio de la aplicación "optimtool" de Matlab , obteniendo resultados mixtos entre los modelos utilizados. Como principal conclusión se tiene el desarrollo de la Ecuación 3, la cual presenta un modelo de mejor ajuste para cada uno de los sitios, obteniéndo valores adecuados de los parámetros de control (RSS, F y R 2 ), pero no así de la aplicación de las mismas en otros sitios. Palabras clave: Corrosión atmosférica, modelado, velocidad de corrosión, acero de baja aleación AbstractFrom corrosion atmospheric rate data and its relationship with environmental variables of different Costa Rica locations, mathematical evaluations of typical models for corrosion rate estimation, were performed. Contamination data and atmospheric parameters along with gravimetric corrosion rate are modeled through Matlab's application "optimtool", yielding mixed results for the models. As main result, the development of equation 3, delivers a model of best adjustment for each site, which generates aceptable values for control parameters (RSS, F y R 2 ), but not for the application of same model for other sites.
The Corrosion maps used are to display quickly the different situations in a country. These maps developed are for low alloy steel in Costa Rica depending on climatic data and pollutant levels, considering the different regulations associated with ISO 9223 and models developed by the Center for Research in Corrosion (CICorr). The atmosphere in Costa Rica has high rates of Brooks, considered very corrosive. The corrosion controlling atmospheric parameters are the relative humidity (RH) and Wetting Time (TWH) associated with low levels of pollution and rural type atmospheres. The corrosion rates are between 25 and 80μm*yr-1 (Class 3 and 4 according to ISO 9223). Local models associated with the controlling parameters are more suitable for estimating the corrosion according to ISO 9223.
ResumenEl objetivo de este proyecto fue evaluar la corrosión por picadura en recipientes de cocina, fabricados a partir de aleaciones de aluminio; mediante la caracterización microscópica (metalografía y microscopía electrónica de barrido) de las mismas y su comportamiento electroquímico en un medio en específico.Las muestras utilizadas fueron las aleaciones: 1050, 1050 baja en cobre, 1200 y una aleación 1050 pero que ya había sido usado por parte del usuario final, la cual había presentado picaduras.Entre los resultados más importantes se tiene que los distintos materiales utilizados no presentan diferencias en cuanto a susceptibilidad de picadura en igualdad de condiciones, según norma ASTM G100-89 Standard Test Method for Conducting Cyclic Galvanostaircase Polarization.Palabras clave: Corrosión por picadura, microscopía, ensayos electroquímicos, aleación de aluminio. AbstractThe main objective of this investigation was to study pitting corrosion on aluminum pots by microscopic characterization and their electrochemical behavior in a specific job solution
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.