Flexible epoxy network loaded with high amount of ionic liquid (IL) 1‐decyl‐3‐methylimidazolium bromide ([DMIM]Br) has been reported by using a mixture of polyol amine as curing agent. The IL presents good electrochemical response even at 170 °C, as no evidence of redox reactions was observed. The incorporation of as high as 50 wt % of this IL within the epoxy matrix resulted in solid and flexible electrolyte with good thermal stability below 180 °C, as measured by thermogravimetric analysis and ionic conductivity of around 10−6 S cm−1 at room temperature and higher than 10−3 S cm−1 at high temperature. This electrolyte presented a prodigious potential for applications in electrochemical devices at high temperature like batteries and supercapacitors, and the flexibility of this solid electrolyte persist at low temperature because of its low glass transition temperature. Furthermore, leakage problems were not observed. Thereby, impedance spectroscopy and cyclic voltammetry were performed to characterize the electrochemical properties. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2018, 135, 45838.

Graphene oxide (GO) and its reduced version (RGO) were prepared and functionalized with phenyl glycidol chlorophosphate (PGC) to obtain the corresponding GO‐PGC and RGO‐PGC materials. These graphene systems were used to prepare thermosetting composites with a tetrafunctional epoxy resin, 4,4′‐methylenebis(N,N‐diglycidylaniline) (TGMDA) cured with 4,4′‐diamino‐diphenyl‐sulfone (DDS). The systems were evaluated by dynamic mechanical analysis at constant strain and temperature sweeps to estimate the viscoelastic properties and relaxation phenomena at long time, which is important for modeling the mechanical long‐term behavior. The time temperature superposition (TTS) principle was employed for the construction of a master curve. The addition of the graphene‐type fillers shifted the time when the relaxation phenomena start to occur towards higher values, suggesting a better working temperature and durability of the corresponding nanocomposites when compared to the neat epoxy network. This phenomenon is more pronounced for the systems prepared with functionalized graphenes. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2017, 134, 44816.

EVA systems, using an environmentally friendly organoclay modified with a non-ionic and free of ammonium ions modifier (BN-AM), were prepared in a single-screw laboratory extruder and characterized by rheological, morphological and thermal properties. WAXD analysis suggested that the nanocomposites with 1.5 wt% of BN-AM presented an exfoliated structure, while the rheological results showed that the nanocomposites with BN-AM organoclay tended to present a more pronounced shear thinning behavior when compared to EVA and the nanocomposites with the traditional organoclay. The SEM/EDS analysis by using elemental mappings showed good dispersion of the organoclays (BN-AM and BN-CT) in the EVA matrix. Thermogravimetry analysis showed an improvement in thermal stability of EVA when the non-ionic modifier was used instead of the traditional one. In general, it was concluded that the addition of low content of BN-AM organoclay in EVA matrices is a promising option for the production of nanocomposites.