Purpose: RENEB, 'Realising the European Network of Biodosimetry and Physical Retrospective Dosimetry,' is a network for research and emergency response mutual assistance in biodosimetry within the EU. Within this extremely active network, a number of new dosimetry methods have recently been proposed or developed. There is a requirement to test and/or validate these candidate techniques and inter-comparison exercises are a well-established method for such validation. Materials and methods: The authors present details of inter-comparisons of four such new methods: dicentric chromosome analysis including telomere and centromere staining; the gene expression assay carried out in whole blood; Raman spectroscopy on blood lymphocytes, and detection of radiationinduced thermoluminescent signals in glass screens taken from mobile phones. Results: In general the results show good agreement between the laboratories and methods within the expected levels of uncertainty, and thus demonstrate that there is a lot of potential for each of the candidate techniques. INTERNATIONAL JOURNAL OF RADIATION BIOLOGY, 2017 VOL. 93, NO. 1, 99-109 http://dx.doi.org/10.1080/09553002.2016 Conclusions: Further work is required before the new methods can be included within the suite of reliable dosimetry methods for use by RENEB partners and others in routine and emergency response scenarios.

No abstract

The objective of this study was to improve the precision of linear energy transfer (LET) measurements using $$\text {Al}_2\text {O}_3\text {:C}$$ Al 2 O 3 :C optically stimulated luminescence detectors (OSLDs) in proton beams, and, with that, improve OSL dosimetry by correcting the readout for the LET-dependent ionization quenching. The OSLDs were irradiated in spot-scanning proton beams at different doses for fluence-averaged LET values in the (0.4–6.5) $$\hbox {keV}\, \upmu \hbox {m}^{-1}$$ keV μ m - 1 range (in water). A commercial automated OSL reader with a built-in beta source was used for the readouts, which enabled a reference irradiation and readout of each OSLD to establish individual corrections. Pulsed OSL was used to separately measure the blue (F-center) and UV ($$F^+$$ F + -center) emission bands of $$\text {Al}_2\text {O}_3\text {:C}$$ Al 2 O 3 :C and the ratio between them (UV/blue signal) was used for the LET measurements. The average deviation between the simulated and measured LET values along the central beam axis amounts to 5.5% if both the dose and LET are varied, but the average deviation is reduced to 3.5% if the OSLDs are irradiated with the same doses. With the measurement procedure and automated equipment used here, the variation in the signals used for LET estimates and quenching-corrections is reduced from 0.9 to 0.6%. The quenching-corrected OSLD doses are in agreement with ionization chamber measurements within the uncertainties. The automated OSLD corrections are demonstrated to improve the LET estimates and the ionization quenching-corrections in proton dosimetry for a clinically relevant energy range up to 230 MeV. It is also for the first time demonstrated how the LET can be estimated for different doses.

Objective: This work investigates the use of Al2O3:C and Al2O3:C,Mg optically stimulated luminescence (OSL) detectors to determine both the dose and the radiation quality in light ion beams. The radiation quality is here expressed through either the linear energy transfer (LET) or the closely related metric Qeff, which depends on the particle's speed and effective charge. The derived LET and Qeff values are applied to improve the dosimetry in light ion beams.

Approach: OSL detectors were irradiated in mono-energetic 1H−, 4He−, 12C−, and 16O−ion beams. The OSL signal is associated with two emission bands that were separated using a pulsed stimulation technique and subjected to automatic corrections based on reference irradiations. Each emission band was investigated independently for dosimetry, and the ratio of the two emission intensities was parameterized as a function of fluence- and dose-averaged LET, as well as Qeff. The determined radiation quality was subsequently applied to correct the dose for ionization quenching.

Main results: For both materials, the Qeff determinations in 1H− and 4He−ion beams are within 5 % of the Monte Carlo simulated values. Using the determined radiation quality metrics to correct the non-linear (ionization quenched) detector response leads to doses within 2 % of the reference doses. 

Significance: Al2O3:C and Al2O3:C,Mg OSL detectors are applicable for dosimetry and radiation quality estimations in 1H- and 4He-ions. Only Al2O3:C,Mg shows promising results for dosimetry in 12C-ions. Across both materials and the investigated ions, the estimated Qeff values were less sensitive to the ion type than the estimated LET values. The reduced uncertainties suggest new possibilities for simultaneously estimating the physical and biological dose in particle therapy with OSL detectors.

No abstract

No abstract

The full-text may be used and/or reproduced, and given to third parties in any format or medium, without prior permission or charge, for personal research or study, educational, or not-for-prot purposes provided that:• a full bibliographic reference is made to the original source • a link is made to the metadata record in DRO • the full-text is not changed in any way The full-text must not be sold in any format or medium without the formal permission of the copyright holders.

A set of garment polyester-mix fabrics were tested for their potential suitability as surrogate dosimetry materials using optically and thermally stimulated luminescence techniques. A strong native blue-stimulated optically stimulated luminescence and thermoluminescence signal was observed with unirradiated samples, but this could be avoided by measurement of infra-red stimulated luminescence, and a sample of blue polyester-cotton mix fabric exhibited particularly high sensitivity to radiation dose. However, near complete fading at room temperature within several hours and rapid bleaching of the signal when exposed to daylight limit the deployment of this mode of measurement. The fading behaviour is critically dependent on the atmosphere in which the material is measured and on the storage conditions, where a reduction in oxygen significantly reduces the rate of fading. A cathodoluminescence study of the samples performed in a scanning electron microscope revealed complex emission spectra obtained with spatially integrated measurements and, in one fabric examined in more detail, the spatially resolved emission was found to vary in intensity and wavelength within the polyester fibre filaments which is likely to be associated with differences in crystallinity.