Synchronous Magnet Generator (PMSG) is one of the main components of wind power generation. This generator has excellent low speed applied especially for less strong winds. Electromotive Force (EMF) output is expected to be enhanced for higher PMSG efficiency. This research aims to analyze the influence of thick and magnetic types on EMF Back PMSG 12S8P. Thickness and type of magnets vary to get the highest EMF output. The thickness is variated at a value of 3 mm and 6 mm, while the magnetic material used Neodymium Iron Boron (NdFeB) and PM12 Br 1.2 Mur 1. Linkage flux value is generated with Finite ElemenMethode (FEM) using Magnet 7,5 Software for each variation. From analyze results and compared to other variations, the highest EMF value obtained from the variation in magnetic thickness 6 mm with material type PM12 Br 1.2 Myrrh 1 with EMF value reaching 21.13122 Volt.
Utilization of wind energy potential has resulted in developments in the design of a permanent magnetic generator of 18 16 pole slots. In the design of a permanent magnet generator 18 16 pole slots are only able to produce an efficiency of 70%. This research aims to increase the efficiency of these generators. The paper will conduct experiments by inserting the input of permanent magnetic materials to see the influence of the permanent magnetic material Ceramic Ferrite, PM12: Br 1.2 nut 1.0, Neodymium Iron Boron, and Samarium cobalt on the characteristics and efficiency of the 18s16p permanent magnet generator using finite element method-based software. The results of experiments on models using PM12: Br 1.2 mur 1.0 produced the greatest efficiency of 91%, followed by Neodymium Iron Boron material at 90%, then Samarium cobalt material at 89%, and CeramicFerrite at 87%. Abstrak − Pemanfaatan potensi energi angin telah menghasilkan perkembangan pada perancangan generator magnet permanen 18 slot 16 pole. Pada perancangan generator magnet permanen 18 slot 16 pole hanya mampu menghasilkan efisiensi sebear 70%. Penelitian ini bertujuan untuk menaikkan efisiensi dari generator tersebut. Pada paper ini akan melakukan percobaan dengan memasukkan inputan material permanen magnet untuk melihat pengaruh dari material magnet permanent Ceramic Ferrite, PM12: Br 1.2 mur 1.0, Neodymium Iron Boron, dan Samarium cobalt terhadap karakteristik dan efisiensi dari generator magnet permanen 18s16p dengan mengggunakan software berbasis Finite Element Method. Hasil percobaan pada model yang menggunakan material PM12: Br 1.2 mur 1.0 menghasilkan efisiensi terbesar yaitu 91%, diikuti oleh material Neodymium Iron Boron yaitu sebesar 90%, lalu material Samarium cobalt sebesar 89%, dan Ceramic Ferrite sebesar 87%.
Pengolahan limbah plastik menjadi agregat kasar alternatif sebagai bahan campuran beton menjadi salah satu solusi di bidang ketekniksipilan dalam upaya meminimalisir semakin banyaknya limbah plastik. Penelitian ini menggunakan jenis plastik adalah Polyethylene Terephtalate (PET) yang biasa ditemukan pada botol air mineral. Variasi penambahan agregat plastik (AP) terhadap agregat alam (AA) adalah 1) AP = 0% dan AA = 100%, 2) AP = 50% dan AA = 50%, 3) AP = 75% dan AA = 25%, dan 4) AP = 100% dan AA = 0%. Variasi gradasi agregat dilakukan 1) #19 mm = 10%, #9,5 mm = 40%, dan #4,75 mm = 50%, 2) #19 mm = 10%, #9,5 mm = 35 %, dan #4,75 mm = 55%, dan 3) #19 mm = 5%, #9,5 mm = 45%, dan #4,75 mm = 50%. Berdasarkan hasil uji kuat tekan dan berat isi beton ringan yang menghasilkan campuran terbaik adalah variasi campuran AP=75% dan AA = 25% dan gradasi campuran #19 mm = 10%, #9,5 mm = 35 %, dan #4,75 mm = 55%. Kuat tekan sebesar 11,1 MPa dan berat isi sebesar 1687,9 kg/m3. Benda uji memenuhi persyaratan berat isi tetapi tidak memenuhi standar kuat tekan untuk beton ringan struktural. Sedangkan penelitian yang dilakukan oleh Supratikno dan Ratnanik (2019) dengan menggunakan material yang sama menghasilkan nilai kuat tekan sebesar 10,14 Mpa dan berat isi sebesar 2260 Kg/m3. Data kuat tekan dan berat isi mengindikasikan pada penelitian ini terjadi peningkatan kualitas benda uji yang dihasilkan terhadap penelitian sebelumnya yang dilakukan Supratikno dan Ratnanik (2019).
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.