Surfactants can be used to increase the solubility of poorly soluble drugs in water and to increase drug bioavailability. In this article, the aqueous solubilization of the nonsteroidal, antiinflammatory drug ibuprofen is studied experimentally and theoretically in micellar solutions of anionic (sodium dodecyl sulfate, SDS), cationic (dodecyltrimethylammonium bromide, DTAB), and nonionic (dodecyl octa(ethylene oxide), C12E8) surfactants possessing the same hydrocarbon "tail" length but differing in their hydrophilic headgroups. We find that, for these three surfactants, the aqueous solubility of ibuprofen increases linearly with increasing surfactant concentration. In particular, we observed a 16-fold increase in the solubility of ibuprofen relative to that in the aqueous buffer upon the addition of 80 mM DTAB and 80 mM C12E8 but only a 5.5-fold solubility increase upon the addition of 80 mM SDS. The highest value of the molar solubilization capacity (chi) was obtained for DTAB (chi = 0.97), followed by C12E8 (chi = 0.72) and finally by SDS (chi = 0.23). A recently developed computer simulation/molecular-thermodynamic modeling approach was extended to predict theoretically the solubilization behavior of the three ibuprofen/surfactant mixtures considered. In this modeling approach, molecular-dynamics (MD) simulations were used to identify which portions of ibuprofen are exposed to water (hydrated) in a micellar environment by simulating a single ibuprofen molecule at an oil/water interface (modeling the micelle core/water interface). On the basis of this input, molecular-thermodynamic modeling was then implemented to predict (i) the micellar composition as a function of surfactant concentration, (ii) the aqueous solubility of ibuprofen as a function of surfactant concentration, and (iii) the molar solubilization capacity (chi). Our theoretical results on the solubility of ibuprofen in aqueous SDS and C12E8 surfactant solutions are in good agreement with the experimental data. The ibuprofen solubility in aqueous DTAB solutions was somewhat overpredicted because of challenges associated with accurately modeling the strong electrostatic interactions between the anionic ibuprofen and the cationic DTAB. Our results indicate that computer simulations of ibuprofen at a flat oil/water interface can be used to obtain accurate information about the hydrated and the unhydrated portions of ibuprofen in a micellar environment. This information can then be used as input to a molecular-thermodynamic model of self-assembly to successfully predict the aqueous solubilization behavior of ibuprofen in the three surfactant systems studied.
An important property of micelles with particular significance in pharmacy is their ability to increase the solubility of poorly soluble drugs in water, thus increasing their bioavailability. In this work, the solubilization of ibuprofen (IBU) was studied in micellar solutions of three surfactants possessing the same hydrocarbon tail but different hydrophilic head groups, namely sodium dodecyl sulphate (SDS), dodecyltrimethylammonium bromide (DTAB), and n-dodecyl octa(ethylene oxide) (C 12 EO 8). The results showed that, irrespective of the surfactant type, the solubility of IBU increased linearly with increasing surfactant concentration, as a consequence of the association between the drug and the micelles. The 80 mM DTAB and the 80 mM C 12 EO 8 micellar solutions resulted in a 16fold increase in solubility of IBU when compared to the buffer solution, whereas the 80 mM SDS micellar solution resulted in a 5.5-fold increase in IBU solubility. The highest value of molar solubilization capacity (χ) was obtained with DTAB, χ = 0.97, followed by C 12 EO 8 , χ = 0.72, and finally SDS, χ = 0.23. However, due to the stronger tendency of the nonionic surfactant in forming micelles in solution, at the same surfactant concentration, we obtained the same solubility of IBU in both DTAB and C 12 EO 8 .
A series of 3-acetyl-2,5-disubstituted-2,3-dihydro-1,3,4-oxadiazole derivatives was synthesized and their activity screened in vitro against Staphylococcus aureus, Trypanosoma cruzi, and Candida albicans. The bioactivity was expressed as minimum inhibitory concentration (MIC) for S. aureus strains, and as fifty-percent inhibitory concentration (IC(50)) of parasite population growth for T. cruzi. A molecular modeling approach was performed to establish qualitative relationships regarding the biological data and the compounds' physicochemical properties. The 5-(4-OC(4)H(9)Ph, 5l), and 5-(4-CO(2)CH(3)Ph, 5o) derivatives were the most active compounds for S. aureus ATCC 25923 (MIC=1.95-1.25 μg/mL) and T. cruzi (IC(50)=7.91 μM), respectively. Also, a preliminary evaluation against C. albicans involving some compounds was performed and the 5-(4-CH(3)Ph, 5e) derivative was the most active compound (MIC=3.28-2.95 μg/mL). In this preliminary study, all synthesized 3-acetyl-2,5-disubstituted-2,3-dihydro-1,3,4-oxadiazole derivatives were active against all microorganisms tested.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.