No abstract

Graphitic carbon nitride (C3N4) was synthesised from melamine at 550 °C for 4 h in the argon atmosphere and then was reheated for 1–3 h at 500 °C in argon. Two band gaps of 2.04 eV and 2.47 eV were observed in all the synthetized materials. Based on the results of elemental and photoluminescence analyses, the lower band gap was found to be caused by the formation of vacancies. Specific surface areas of the synthetized materials were 15–18 m2g−1 indicating that no thermal exfoliation occurred. The photocatalytic activity of these materials was tested for hydrogen generation. The best photocatalyst showed 3 times higher performance (1547 μmol/g) than bulk C3N4 synthetized in the air (547 μmol/g). This higher activity was explained by the presence of carbon (VC) and nitrogen (VN) vacancies grouped in their big complexes 2VC + 2VN (observed by positron annihilation spectroscopy). The effect of an inert gas on the synthesis of C3N4 was demonstrated using Graham´s law of ammonia diffusion. This study showed that the synthesis of C3N4 from nitrogen-rich precursors in the argon atmosphere led to the formation of vacancy complexes beneficial for hydrogen generation, which was not referred so far.

No abstract

No abstract

No abstract

In this paper, temperature and concentration dependencies on density and surface tension of liquid Fe-C-O-Cr alloys (1.93 - 4.80 wt.% Cr) were investigated in high-temperature resistance observation furnace by a sessile drop method during heating from liquidus temperature to 1600?C. The interfacial characteristics (interfacial tension, wetting angle, work of adhesion, and spreading coefficient) of liquid alloy/alumina system were also determined depending on temperature. The effect of temperature and chromium content on surface and interfacial properties was proven in case of all examined alloys. Based on the fact that the content of surface-active elements such as oxygen (up to 195 ppm) and sulfur (up to 545 ppm) was higher, the influence of activities of both mentioned elements on surface tension of alloy samples was assessed. Particular attention was paid to the dependence of the surface tension temperature coefficient on oxygen and sulfur activity.

No abstract

No abstract