The reaction of SO 2 with fly ash in the presence of O 2 and H 2 O involves a series of reactions that lead to the formation of SO 3 and eventually H 2 SO 4 . Homogeneous experiments were conducted to evaluate the effects of the procedural variables, i.e., temperature, gas concentrations, and residence time, on the post-combustion conversion of SO 2 to SO 3 . The results were compared to existing global kinetics and found to be dependent upon SO 2 , O 2 , residence time, and temperature and independent of H 2 O content. For a residence time of 1 s, temperatures of about 900°C are needed to have an observable conversion of SO 2 to SO 3 . Literature suggested that the conversion of SO 2 to SO 3 is dependent upon the iron oxide content of the fly ash. Experiments using three different fly ash samples from Australian sub-bituminous coals were used to investigate the catalytic effects of fly ash on SO 2 conversion to SO 3 at a temperature range of 400−1000°C. It was observed that fly ash acts as a catalyst in the formation of SO 3 , with the largest conversion occurring at 700°C. A homogeneous reaction at 700°C, without fly ash present, converted 0.10% of the available SO 2 to SO 3 . When fly ash was present, the conversion increased to 1.78%. The catalytic effect accounts for roughly 95% of the total conversion. Average SO 3 /SO 2 conversion values between fly ash derived from air and oxy-fuel firing and under different flue gas environments were found to be similar.

This paper presents results of experiments performed at a 20 kW once-through combustion rig of the Institute of Combustion and Power Plant Technology (IFK) of the University of Stuttgart. A methodology to investigate oxy-fuel process configurations was used in which impurities were injected to the oxidant gas of the once-through reactor to simulate different extents of oxy-fuel recycle gas treatment. Three Australian coals, which had previously been tested in the Aioi furnace of IHI in Japan, were used in the experiments. A comprehensive set of total (Hg tot ), elemental (Hg 0 ), and oxidized (Hg 2+ ) mercury concentrations was measured for various air and oxy-fuel combustion conditions. These data enable an evaluation of process parameters that influence the Hg emissions of an oxy-fuel combustion process. A theoretical mass balance between Hg fed to the process (fuel and Hg 0 injection) and Hg measured before the filter matched well, indicating that no mercury was captured by fly ash at high temperatures. The capture of Hg 0 and oxidized Hg 2+ by ash in a baghouse filter has been determined for all experiments. Measured Hg concentrations show an increase when switching from air to oxy-fuel operation for all investigated coals and oxy-fuel settings, even when no additional Hg 0 is injected to the oxidant gas. Moreover, the Hg 2+ /Hg tot ratios in the flue gas are higher during oxy-fuel combustion. The Hg capture by ash in the baghouse filter has been found to reduce the Hg emissions considerably. Reduction rates in a range between 18 and 51% for air and between 11 and 29% for oxy-fuel combustion were observed.

The sulfur oxide (SO x ) concentrations during oxy-fuel combustion are generally higher compared to conventional air firing. The higher SO x concentrations, particularly sulfur trioxide (SO 3 ) in combination with high concentration of water in the recycled flue gas, increase the sulfuric acid dew point temperature in oxy-fuel fired systems, thereby increasing allowable flue gas temperatures and reducing the thermal efficiency of a power plant. This paper presents results of experiments carried out at a 20 kW once-through combustion rig of the Institute of Combustion and Power Plant Technology (IFK) of the University of Stuttgart simulating different extents of oxy-fuel recycle gas cleaning by impurities injection to the oxidant gas of a once-through combustion reactor. Three Australian coals that have previously been tested under air and oxy-fuel conditions at the Aioi furnace of IHI in Japan were used in the experiments. The SO x emissions were measured, conversion ratios of sulfur dioxide (SO 2 ) to SO 3 were calculated, and results were compared with existing literature, finding good agreement. The experiments with different extents of recycle gas cleaning and therefore different SO 2 levels in the system, revealed differences in the SO 3 generation behavior: A coal-specific trend of increasing conversion ratios of SO 2 to SO 3 with increased flue gas SO 2 levels was observed that could be related to the ash composition of the three different coals. The capture of SO x in a baghouse filter was also evaluated. Acid dew point temperatures (ADPs) for the flue gas were calculated for the various firing conditions. Acid dew point (ADP) temperatures increased by up to 50 °C when changing from air to oxy-firing with recycling of H 2 O and SO 2 . Considerable differences in the ADPs were found for different extents of oxy-fuel recycle gas treatment and were evaluated in respect to power plant efficiency implications.

Death due to diseases from poor sanitation is a serious global issue and it has become one of the priorities of the United Nations' Sustainable Development Goals (i.e., SDG6). This SDG6 aims to provide adequate improved sanitation facilities to over 2.3 billion people around the world who have no or limited access to sanitation, wherein more than two-thirds of these un-served people live in rural areas. One of the strategies for addressing this global issue is through emerging sustainable sanitation technologies such as the Eco-Toilet System (ETS), which uses small amounts of water or is even waterless and recovers nutrients from human waste thereby promoting water-energy conservation, improved sanitation and supplement nutrients essential to plant growth. Social acceptance, however, remains a key barrier in deploying the ETS. A social perception study on the use of the ETS was conducted in a rural community in Mulanay, Philippines. The researchers analyzed the proposed combined technology acceptance model and theory of planned behavior (C-TAM-TPB) using multiple linear regression and the Mann-Whitney U-test to evaluate the perceptions and attitudes of a rural community towards the use of the ETS. The results showed that more than 50% of the respondents are aware of the nutrient value of human excreta and believe that it is usable as fertilizer; however, less than 25% prefer to utilize it for food production. Results also indicate that the behavior of the users is driven by their attitude (β = 0.420, p-value < 0.010). Moreover, the Mann-Whitney U-test results revealed that people who are knowledgeable of the nutrient value of human excreta and are willing to collect them have more positive attitude towards the ETS.

Ash produced during oxy-fuel combustion is expected to differ from ash produced during air combustion because of the higher CO 2 and SO 2 atmospheres in which it is generated. For a quantitative understanding of the sulfation behavior of fly ash in oxy-fuel combustion, fly ash from three commercial Australian sub-bituminous coals was tested and decomposed under an inert atmosphere. Thermal evolved gas analysis was completed for ash produced in both air and oxy-fuel environments. Pure salts were also tested under the same conditions to allow for identification of the species in the ash that capture sulfur, along with thermodynamic modeling using FactSage 6.3. Sulfur evolved during the decomposition of air and oxy-fuel fly ash was compared to the total sulfur in the ash to close the sulfur balance. Both total sulfur captured by the ash and sulfur evolved during decomposition were higher for oxy-fuel fly ash than their air counterparts. Correlations of capture with ash chemistry are presented.

A B S T R A C TThe phytoremediation potential of three bamboo species, i.e. Bambusa merilliana, Bambusa blumeana, and Dendrocalamus asper, were evaluated for their total Cu uptake ability in hydroponics. Dendrocalamus asper proved to be the most efficient in terms of Cu phytoremediating potential with a constant positive uptake of 80 μM in a contaminated substrate and a bioconcentration factor of 50.57. Copper accumulation was found to concentrate the most in the roots compared to the amount translocated in the shoots. Analysis of the Cu uptake of D. asper roots at varying concentrations of Cu contamination (40, 80 and 120 μM) allowed for the fitting of the kinetics of Cu uptake and removal with existing kinetic models. The rate of copper removal per mass of plant was the best for the 0 th order model in the 80 μM solution with an R 2 of 0.954 and rate constant of 3.136 mg-kg À1 d À1 . The accumulation of Cu within the roots on day 7 (7d) followed the Michaelis-Menten model with an R 2 of 0.970. The Michaelis-Menten constant (K M ) was 4.87 mg/L and maximum accumulation velocity (Vmax) was 66.26 mg Cukg À1 -day À1 . Results suggest that D. asper is a potential hyperaccumulator plant that can be used in clean-up of domestic and industrial wastes present along river systems in the Philippines.

The Integrated Water System (IWS) offers alternative water and sanitation services that can potentially benefit rural communities experiencing water scarcity. The IWS described in this study comprises three systems: The Rainwater Harvesting System (RWHS), Water Treatment System (WTS), and Eco-Toilet System (ETS). RWHS and WTS make use of rainwater, which can be utilized for several domestic uses, especially during wet season. ETS has several benefits to users including promotion of environmental and public health, as well as food security. Despite the potential benefits of the IWS components, the perceived acceptance of its users threatens the success of its implementation. This study focuses on determining the significant factors that can influence the social acceptance of IWS in the Municipality of Mulanay, Quezon Province, Philippines. This study considers behavioral intention as an indicator of social acceptance of the IWS components. The framework of this study is based on the combined technology acceptance model and theory of planned behavior (C-TAM-TPB) concept. C-TAM-TPB was analyzed using Partial Least Square–Structural Equation Modeling (PLS–SEM). The result of the C-TAM-TPB evaluation reveals that the user’s attitude towards use (ATU), including its significant predictors, can promote behavioral intention towards use of the IWS components. This study can further improve the development of IWS projects.

No abstract