In this paper we report on the transport properties of protic and aprotic ionic liquids of the imidazolium cation (C2C1Im(+) or C2HIm(+)) and the TFSI(-) or TfO(-) anion as a function of added water. We observe that the self-diffusion coefficient of the ionic species increases upon addition of water, and that the cation diffuses faster than the anion in the entire water concentration range investigated. We also observe that the overall increase of anionic and cationic diffusion coefficients is significant for C2HImTfO while it is rather weak for C2C1ImTFSI, the former being more hydrophilic. Moreover, the difference between cationic and anionic self-diffusivity specifically depends on the structure of the ionic liquid's ions. The degree of ion-ion association has been investigated by comparing the molar conductivity obtained by impedance measurements with the molar conductivity calculated from NMR data using the Nernst-Einstein equation. Our data indicate that the ions are partly dissociated (Λimp/ΛNMR in the range 0.45-0.75) but also that the degree of association decreases in the order C2HImTfO > C2HImTFSI ≈ C2C1ImTfO > C2C1ImTFSI. From these results, it seems that water finds different sites of interaction in the protic and aprotic ionic liquids, with a strong preference for hydrogen bonding to the -NH group (when available) and a stronger affinity to the TfO anion as compared to the TFSI. For the protic ionic liquids, the analysis of (1)H NMR chemical shifts (upon addition of H2O and D2O, respectively) indicates a water-cation interaction of hydrogen bonding nature. In addition, we could probe proton exchange between the -NH group and deuterated water for the protic cation, which occurs at a significantly faster rate if associated with the TfO anion as compared to the TFSI.
From the assignment of the solid-state (13)C NMR signals in the C4 region, distinct types of crystalline cellulose, cellulose at crystalline surfaces, and disordered cellulose can be identified and quantified. For regenerated cellulose, complete (13)C assignments of the other carbon regions have not previously been attainable, due to signal overlap. In this study, two-dimensional (2D) NMR correlation methods were used to resolve and assign (13)C signals for all carbon atoms in regenerated cellulose. (13)C-enriched bacterial nanocellulose was biosynthesized, dissolved, and coagulated as highly crystalline cellulose II. Specifically, four distinct (13)C signals were observed corresponding to conformationally different anhydroglucose units: two signals assigned to crystalline moieties and two signals assigned to non-crystalline species. The C1, C4 and C6 regions for cellulose II were fully examined by global spectral deconvolution, which yielded qualitative trends of the relative populations of the different cellulose moieties, as a function of wetting and drying treatments.
Solutions of cellulose in a mixture of tetrabutylammonium fluoride and dimethyl sulfoxide (TBAF/DMSO) containing small and varying amounts of water were studied by nuclear magnetic resonance (NMR). By measuring the composition dependences of 19 F NMR and 1 H NMR chemical shifts and line widths, details on the dissolution and gelation mechanisms for cellulose in TBAF/DMSO were elucidated. Our results suggest that the strongly electronegative fluoride ions act as hydrogen bond acceptors to cellulose hydroxyl groups, thus dissolving the polymer by breaking the cellulose-cellulose hydrogen bonds and by rendering the chains an effective negative charge. It was found that the fluoride ions also interact strongly with water. Small amounts of water remove the fluoride ions from the cellulose chains and allow reformation of the cellulose-cellulose hydrogen bonds, which leads to formation of highly viscous solutions or gels even at low cellulose concentrations.
We report, by employing time resolved Raman and nuclear magnetic resonance (NMR) spectroscopy, on the gelation process in ionogels. These are prepared from a non-aqueous sol-gel reaction in the ionic liquid 1-hexyl-3-methylimidazolium bis(trifluoromethanesulfonyl)imide (C(1)C(6)ImTFSI). Raman and NMR spectroscopies are complementarily used to decipher the chemical reactions that occur during synthesis and to clarify the state of the ionic liquid up to, and well beyond, gelation. We find that the ionic liquid concentration affects both the reaction rate and the gelation time (t(gel)). In addition, NMR and Raman data reveal inherently different roles of the cation and the anion in the gelation process. While the oscillating behavior of the TFSI Raman signature at ~740 cm(-1) is mainly an effect of solvation and chemical composition, the evolution of the relative chemical shifts (Δδ) of different hydrogen atoms on the imidazolium correlates with gelation, as does the width of the chemical shift of -OH containing groups (δ(OH)). We also observe that in the confined state the TFSI anion preferably adopts the cisoid conformation and experiences a stronger ion-ion interaction.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.