Monolithic perovskite/crystalline silicon tandem solar cells hold great promise for further performance improvement of well-established silicon photovoltaics; however, monolithic tandem integration is challenging, evidenced by the modest performances and small-area devices reported so far. Here we present first a low-temperature process for semitransparent perovskite solar cells, yielding efficiencies of up to 14.5%. Then, we implement this process to fabricate monolithic perovskite/silicon heterojunction tandem solar cells yielding efficiencies of up to 21.2 and 19.2% for cell areas of 0.17 and 1.22 cm(2), respectively. Both efficiencies are well above those of the involved subcells. These single-junction perovskite and tandem solar cells are hysteresis-free and demonstrate steady performance under maximum power point tracking for several minutes. Finally, we present the effects of varying the intermediate recombination layer and hole transport layer thicknesses on tandem cell photocurrent generation, experimentally and by transfer matrix simulations.

In the present paper, the structural and electrical performances of microcrystalline silicon (lc-Si:H) single junction solar cells codeposited on a series of substrates having different surface morphologies varying from V-shaped to U-shaped valleys, are analyzed. Transmission electron microscopy (TEM) is used to quantify the density of cracks within the cells deposited on the various substrates. Standard 1 sun, variable illumination measurements (VIM) and Dark J(V) measurements are performed to evaluate the electrical performances of the devices. A marked increase of the reverse saturation current density (J 0 ) is observed for increasing crack densities. By introducing a novel equivalent circuit taking into account such cracks as non-linear shunts, the authors are able to relate the magnitude of the decrease of V oc and FF to the increasing density of cracks.

To study recombination at the amorphous/crystalline Si (aSi:H/c-Si) heterointerface, the amphoteric nature of silicon (Si) dangling bonds is taken into account. Modeling interface recombination measured on various test structures provides insight into the microscopic passivation mechanisms, yielding an excellent interface defect density reduction by intrinsic aSi:H and tunable field-effect passivation by doped layers. The potential of this model's applicability to recombination at other Si heterointerfaces is demonstrated. Solar cell properties of aSi:H/c-Si heterojunctions are in good accordance with the microscopic interface properties revealed by modeling, that are, e.g., slight asymmetries in the neutral capture cross-sections and band offsets. The importance of atomically abrupt interfaces and the difficulties to obtain them on pyramidally textured c-Si is studied in combination with transmission electron microscopy.

Crystalline silicon wafer (c-Si) can be extremely well passivated by plasma enhanced chemical vapor deposited (PECVD) amorphous silicon (a-Si:H) films. As a result, on flat substrates, solar cells with very high open circuit voltage are readily obtained. On textured substrates however the passivation is more cumbersome, likely due to the presence of localized recombinative paths situated at the pyramid valleys. Here, we show that this issue may be resolved by selecting a silicon substrate morphology featuring large pyramids. Chemical post-texturization treatments can further reduce the surface recombination velocity. This sequence has allowed us to fabricate solar cells with open circuit voltage over 700 mV, demonstrating also on device level the effect of pyramid density and surface micro-roughness on the surface passivation quality.

No abstract

No abstract

No abstract

No abstract