Impurity transport in the T-10 tokamak plasma with ohmic heating is studied in this paper. The values of various impurities densities, measured with the use of passive spectral diagnostics in the visible (Z eff ), active charge exchange measurements (He, C, O), and integral bolometric measurements with absolute extreme ultraviolet detectors (Fe, W) are shown. The experimental data show that accumulation level is growing with impurity nuclear charge and determined by the parameter1.5 , which is common for all sorts of impurities. Accumulation process is determined by neoclassical processes and begins with the increase of impurity content in the plasma and ends with the formation of density profiles more peaked than the n e (r). In discharges with low γ anomalous transport completely dominates. So it prevents the impurity accumulation and flattens their density profiles down to the n e (r). These observations correlates with measured negative (positive) plasma potential in discharges with high γ (low γ). 1D modelling using ASTRA and STRAHL transport codes is performed to describe the behaviour of impurities in a wide range of T-10 ohmic regimes. It is shown that the coefficients of anomalous transport D an and V an established in Krupin et al (1983 Sov. J. Plasma Phys. 9 529-36) and Krupin et al (1985 12th EPS Conf. on Plasma Physics) by describing the density dynamics of injected argon and potassium ions are applicable for the modelling of the He, C, O, W impurity density profiles and their sources. The analysis of the obtained results allows us to state the existence of a common dependence of the anomalous transport for all ions (impurities and deuterons) on the discharge parameters in the T-10 ohmic regimes.

First experimental results of tungsten transport investigation in OH and ECRH plasmas in the T-10 tokamak with W-limiter and movable Li-limiter are presented. It is shown that tungsten tends to accumulate (a joint process of cumulation and peaking) near the plasma axis in ohmic regimes. The cumulation of W is enhanced in discharges with high values of the parameter that coincides with accumulation conditions of light and medium impurities in T-10 plasmas. Experiments with Li-limiter show the immeasurable level of Li3+ (0.3–0.5% of ne) of T-10 CXRS diagnostics because of the low inflow of Li with respect to other light impurities. Nevertheless, the strong influence of lithium on inflow of light and tungsten impurities is observed. In discharges with lithized walls, vanishing of light impurities occurs and values of are obtained. It is also shown that the tungsten density in the plasma center decreases by 15 to 20 times while the W inflow reduces only by 2 to 4 times. In lithized discharges with high γ, the flattening of the tungsten density profile occurs and its central concentration decreases up to 10 times during the on-axis ECRH. This effect is observed together with the increase of the W inflow by 3 to 4 times at the ECRH stage.

Transition to an all-metal wall was realized on T-10 by replacement of graphite limiters with tungsten ones. Light impurity levels remained high and W accumulation in the plasma core was revealed. A movable lithium (Li) limiter was added to investigate the possibility of the limitation of tungsten and light impurity levels in plasma. For the first time, tokamak results on tungsten protection with Li were obtained in OH and ECRH regimes. After lithization the tungsten density in the core dropped more than an order of magnitude, while W influx into plasma decreased 2–4 times. Drastic drops of light impurities in plasma were observed together with improvement of energy confinement time and density limit values. Nevertheless, Li levels in plasma remained low in both OH and ECRH regimes. Li density in the core as low as 0.5% of ne was obtained. Tungsten transport in T-10 plasma was investigated and results on prevention of W accumulation with central ECRH were obtained. Effects of plasma exposure on ITER-grade tungsten plates from limiters were studied. Investigations of density fluctuation with correlation reflectometry confirmed a decrease of fluctuation amplitude on high field side. Modeling showed that this effect can be, to a great extent, explained by the non-locality of reflectometry. Toroidal correlations at a distance of 2.5 m along field lines were studied. Three-wave interaction between geodesic acoustic modes and broad-band turbulence was found by analysis of heavy ion beam probe diagnostics data. The possibility of plasma current control and the prevention of non-thermal electron beams formation at density limit disruption by means of ECR heating and the controlled operation of OH power supply system has been demonstrated. The study of plasma density decay after gas puff switch off during density ramp-up phase in OH regimes and the effect of ‘density pump out’ during ECRH showed that both effects can be explained by the assumption regarding electron transport growth upon reaching marginal pressure profile. A new type of internal transport barrier in the narrow zone near q  =  1 surface has been found.

No abstract

No abstract