No abstract

We validated a single-stranded, DNA aptamer-based, diagnostic method capable of detecting Lipocalin-2 (LCN2), a biomarker from clinically relevant hepatocellular carcinoma (HCC) patient serum, in the sandwich assay format. Nine aptamers (LCN2_apta1 to LCN2_apta9) for LCN2 were screened with SELEX processes, and a sandwich pair (LCN2_apta2 and LCN2_apta4) was finally chosen using surface plasmon resonance (SPR) and dot blotting analysis. The result of the proposed aptamer sandwich construction shows that LCN2 was sensitively detected in the concentration range of 2.5–500 ng mL−1 with a limit of detection of 0.6 ng mL−1. Quantitative measurement tests in HCC patients were run on straight serum and were compared with the performance of the conventional antibody-based ELISA kit. The aptamer sandwich assay demonstrated an excellent dynamic range for LCN2 at clinically relevant serum levels, covering sub-nanogram per mL concentrations. The new approach offers a simple and robust method for detecting serum biomarkers that have low and moderate abundance. It consists of functionalization, hybridization and signal read-out, and no dilution is required. The results of the study demonstrate the capability of the aptamer sandwich assay platform for diagnosing HCC and its potential applicability to the point-of-care testing (POCT) system.

In this paper, whole-bacteria SELEX (WB-SELEX) strategy was adopted to isolate specific aptamers against Vibrio parahaemolyticus. Round selection for V. parahaemolyticus was conducted 11 rounds, including two negative selection rounds. It was determined through real-time PCR amplification and post-SELEX experiment. The selected aptmers had high binding property and specificity to V. parahaemolyticus. Of 28 aptamers tested, VPCA-apta#1 had the highest binding affinity compared to other aptamer candidates obtained. To detect V. parahaemolyticus, aptamer based SPR biosensor platform was constructed and pathogenic bacteria sensing was conducted in two steps. The first step was to construct 5'-biotinylated VPCA-apta#1 binding probe. The second step was to incubate V. parahaemolyticus and test microbes in functionalized SA sensor chip in parallel. Our platform showed significant activity for detecting and discriminating V. parahaemolyticus from other enteric species such as Escherichia coli, Listeria monocytogenes, Sigella sonnei, and Vibrio fischeri. This is the first report on the use of whole-SELEX to isolate DNA aptamers specific for V. parahaemolyticus. We demonstrated the feasibility of using aptamer platform for the detection of V. parahaemolyticus in various food supplies. It might be used in multiple points of care for diagnosing Vibriosis.

The potential copper binding sites in aptamers have been predicted on the basis of secondary structures and the binding affinity of aptamers with copper. Out of the 4 aptamers (Cu-A1 to Cu-A4) selected by SELEX and examined in the present study, the Cu-A2 aptamer shows the highest binding affinity to copper with the lowest K value of 1.83 × 10 M. In order to confirm the binding of copper to the proposed region, the binding affinity was experimentally validated using mutation and deletion analysis. We have confirmed that the high G-C pairing patterns and short stem-interval distance play important roles in copper binding. Aptamer specificity was also verified against diverse heavy metals. We also demonstrate an Aptamer Integrated Recovery Platform (AIRP) to recover copper from acidic mine drainage. AIRP can be easily regenerated at least 20 times without significant deterioration of the retrieval performance. To the best of our knowledge, AIRP is the first demonstration of copper specific recovery using aptamers. This can be scaled up and would have diverse applications in metal contaminated water treatment, recovery and as a potential biosensor for environmental analysis, monitoring, and risk assessment.

No abstract