In situ TiB 2 particle-reinforced 7050Al alloy matrix composites are a new category of particulate metal matrix composites with improved mechanical and physical properties. At present, the study of machining in situ TiB 2 /Al composite is limited and no specific study has been presented on cutting force. Based on previous work, experimental investigation of cutting in situ TiB 2 /Al composite was carried out in this study to investigate the cutting force, shear angle, mean friction angle, and shear stress. The results indicated that the feed rate, instead of cutting speed, has a significant influence on the shear angle, mean friction angle, shear stress, and forces, which is different from cutting ex situ SiC/Al composites. Meanwhile, based on Merchant's theory, a force model, which consists of chip formation and ploughing force, was established to have a better understanding of force generation. A comparison of the results show an acceptable agreement between the force model and experiments. Additionally, at varying feed rates, the linear relationship between the shear angle and mean friction angle is still suitable for cutting in situ TiB 2 /7050Al alloy composites.
The in-situ TiB2/7050Al composite is a new kind of Al-based metal matrix composite (MMC) with super properties, such as low density, improved strength, and wear resistance. This paper, for a deep insight into its cutting performance, involves a study of the chip formation process and finite element simulation during orthogonal cutting in-situ TiB2/7050Al MMC. With chips, material properties, cutting forces, and tool geometry parameters, the Johnson–Cook (J–C) constitutive equation of in-situ TiB2/7050Al composite was established. Then, the cutting simulation model was established by applying the Abaqus–Explicit method, and the serrated chip, shear plane, strain rate, and temperature were analyzed. The experimental and simulation results showed that the obtained material’s constitutive equation was of high reliability, and the saw-tooth chips occurred commonly under either low or high cutting speed and small or large feed rate. From result analysis, it was found that the mechanisms of chip formation included plastic deformation, adiabatic shear, shearing slip, and crack extension. In addition, it was found that the existence of small, hard particles reduced the ductility of the MMC and resulted in segmental chips.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.