When exposed to a partially wetting liquid, many natural and artificial surfaces equipped with complex topographies display a rich variety of liquid interfacial morphologies. In the present article, we focus on a few simple paradigmatic surface topographies and elaborate on the statics and dynamics of the resulting wetting morphologies. It is demonstrated that the spectrum of wetting morphologies increases with increasing complexity of the groove structure. On elastically deformable substrates, additional structures in the liquid morphologies can be observed, which are caused by deformations of the groove geometry in the presence of capillary forces. The emergence of certain liquid morphologies in grooves can be actively controlled by changes in wettability and geometry. For electrically conducting solid substrates, the apparent contact angle can be varied by electrowetting. This allows, depending on groove geometry, a reversible or irreversible transport of liquid along surface grooves. In the case of irreversible liquid transport in triangular grooves, the dynamics of the emerging instability is sensitive to the apparent hydrodynamic slip at the substrate. On elastic substrates, the geometry can be varied in a straightforward manner by stretching or relaxing the sample. The imbibition velocity in deformable grooves is significantly reduced compared to solid grooves, which is a result of the microscopic deformation of the elastic groove material close to the three phase contact line.

No abstract

The laser systems currently used in ophthalmology either have some pulse length dependent side effects or are very expensive due to their complexity. Therefore, a newly developed approach using picosecond laser sources is investigated. These lasers combine the advantages of the low price of currently used short-pulse laser sources with the cold material ablation possibilities of high-end femtosecond sources. The surgeries intended are laser iridotomy, capsulotomy/post-cataract treatment and selective laser-trabeculoplasty (SLT). They are demonstrated on post mortem porcine eyes. The result is a more precise, less frayed tissue ablation with picosecond pulses in comparison to nanosecond pulses. The pulse energy could be reduced to (50 20) µJ per pulse instead of 1mJ to 10mJ per pulse, which is currently applied. The study of shock waves and cavitation bubbles revealed a huge difference in pressure between picosecond pulses (0:25MPa at 50 µJ) and nanosecond pulses (37MPa at 5 mJ). Therefore, the risk of collateral damage leading to potential additional clinical patterns and adverse effects could be significantly reduced.

We demonstrate sub-100 ps pulses with a Yb 3+ :YAG microchip laser passively Q-switched by a Cr 4+ :YAG saturable absorber. By introducing a subcavity, the laser threshold and the saturation energy are decreased which helps to prevent damage and to vary the effective emission and absorption cross sections. Pulse widths of 84 ps, repetition rates of 3.3 kHz and pulse energies of 32 µJ are achieved. This allows direct micromaterial processing e.g. for ophthalmic surgeries. To the best of our knowledge, this is the first sub-100 ps Yb 3+ :YAG/Cr 4+ :YAG microchip laser. A new approximation is used to calculate the rate equations for multiple longitudinal modes and to determine the threshold for single-longitudinal-mode operation.

No abstract

A study of the electrical properties of ITO layers combined with underlying optical interference layers and their optical properties and surface roughness.

This is a study of the potential of IBS for the production of high-quality ITO layers for optical applications with additional electrical requirements. The electrical properties of ITO layers combined with underlying optical interference layers and their optical properties and surface roughness are presented.