XRD, UV-Vis, EXAFS, XANES, and Raman techniques have been used to study the removal of water molecules coordinated to the Cu(II) framework atoms of the novel HKUST-1 metal-organic framework. The dehydration process preserves the crystalline nature of the material, just causing a reduction of the cell volume due to the shrinking of the [Cu 2 C 4 O 8 ] cage. The removal of adsorbed H 2 O molecule makes the framework Cu(II) sites available for interaction with other probe molecules. In situ IR spectroscopy has evidenced the formation at liquid nitrogen temperature of labile Cu(II)‚‚‚CO adducts characterized by a ν(C-O) ) 2178 cm -1 and at 15 K of Cu(II)‚‚‚H 2 adducts characterized by a ν(H-H) ) 4100 cm -1 . To the best of our knowledge, we have observed for the first time a clear signal of Cu(II) carbonyl and dihydrogen complexes formed inside a crystalline microporous hosting matrix. The sinking of the oxygens of the carboxyl units, undergone by the Cu(II) framework ions in the dehydration process, is responsible for the rather low coordinative unsaturation of Cu(II). The important shielding effect of the four oxygen framework atoms is testified by the low polarization factor of the Cu(II) site probed by both CO and H 2 molecules.

Three different porous metal organic framework (MOF) materials have been prepared with and without uncoordinated amine functionalities inside the pores. The materials have been characterized and tested as adsorbents for carbon dioxide. At 298 K the materials adsorb significant amount of carbon dioxide, the amine functionalised adsorbents having the highest CO 2 adsorption capacities, the best adsorbing around 14 wt% CO 2 at 1.0 atm CO 2 pressure. At 25 atm CO 2 pressure, up to 60 wt% CO 2 can be adsorbed. At high pressures the CO 2 uptake is mostly dependent on the available surface area and pore volume of the material in question. For one of the iso-structural MOF pairs the introduction of amine functionality increases the differential adsorption enthalpy (from isosteric method) from 30 to around 50 kJ/mole at low CO 2 pressures, while the adsorption enthalpies reach the same level at increase pressures. The high pressure experimental results indicate that MOF based solid adsorbents can have a potential for use in pressure swing adsorption of carbon dioxide at elevated pressures.

No abstract

The heterobimetallic metal-organic framework {[(BPDC)PtCl(2)](3)(Gd(H(2)O)(3))(2)}.5H(2)O (BPDC = 2,2'-bipyridine-5,5'-dicarboxylate) has been designed and synthesized by hydrothermal methods. The new coordination polymer contains subunits of (BPDC)PtCl(2) (1) where both N atoms of the BPDC ligand are attached to a square-planar Pt(II) center. The two remaining cis coordination sites at Pt(II) are occupied by chloride ions. The final structure (2) of the polymeric network is obtained when Gd(III) ions link together the (BPDC)PtCl(2) units, which are organized in sheets, into larger blocks. These blocks are stacked along the crystallographic [010] direction and are held together by a hydrogen bonding scheme that involves carboxylate oxygen atoms and water molecules in the coordination sphere of Gd. The coordination polymer 2 can be obtained in a single-step reaction or in a two-step synthesis where the corresponding Pt complex (1) was first synthesized followed by reacting 1 with Gd(NO(3))(3).6H(2)O. In situ high temperature powder X-ray diffraction shows that the crystalline coordination polymer transforms into an anhydrous modification at 100 degrees C. This modification is stable to 350 degrees C, at which temperature the structure starts to decompose. The coordination sphere around platinum in the polymer closely resembles organometallic Pt complexes that have been previously found to catalytically or stoichiometrically activate and functionalize hydrocarbon C-H bonds in homogeneous systems.