A 2-then-1-bit/cycle noise-shaping successive-approximation register (SAR) analog-to-digital converter (ADC) for high sampling rate and high resolution is presented. The conversion consists of two phases of a coarse 2-bit/cycle SAR conversion for high speed and a fine 1-bit/cycle noise-shaping SAR conversion for high accuracy. The coarse conversion is performed by both voltage and time comparison for low power consumption. A redundancy after the coarse conversion corrects the error caused by a jitter noise during the time comparison. Additionally, a mismatch error between signal and reference paths is eliminated with the help of a tail-current-sharing comparator. The proposed ADC was designed in a 28 nm CMOS process, and the simulation result shows a 68.2 dB signal-to-noise distortion (SNDR) for a sampling rate of 480 MS/s and a bandwidth of 60 MHz with good energy efficiency.
In this study, a pipelined noise-shaping successive-approximation register analog-to-digital converter (PLNS-SAR ADC) structure was proposed to achieve high resolution and to be free from comparator design requirements. The inter-stage amplifier and integrator of the PLNS-SAR ADC were implemented through a ring amplifier with high gain and speed. The ring amplifier was designed to improve power efficiency and be tolerant to process–voltage–temperature (PVT) variation, and uses a single loop common-mode feedback (CMFB) circuit. By processing residual signals with a single ring amplifier, power efficiency can be maximized, and a low-power system with 30% lower power consumption than that of a conventional PLNS-SAR ADC is implemented. With a high-gain ring amplifier, noise leakage is greatly suppressed, and a structure can be implemented that is tolerant of mismatches between the analog loop and digital correction filters. The measured signal to noise distortion ratio (SNDR) is 70 dB for a 5.15 MHz bandwidth (BW) at a 72 MS/s sampling rate (Fs) with an oversampling ratio (OSR) of 7, and the power consumption is 2.4 mW. The (= SNDR + BW/Power) is 163.5 dB. The proposed structure in this study can achieve high resolution and wide BW with good power efficiency, without a filter calibration process, through the use of a ring amplifier in the PLNS-SAR ADC.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.