Subsurface drip irrigation (SDI) systems are increasingly being used in agriculture in attempts to use the available water more efficiently. The proper design and management of SDI systems requires knowledge of precise distribution of water around emitters. We conducted both field and numerical experiments to evaluate the soil water content distributions between two neighboring emitters when their wetting patterns started to overlap. The experiments involved SDI systems with emitters installed at different depths and with different spacings along the drip lateral. The HYDRUS software package was used to analyze the field data, assuming modeling approaches in which emitters were represented as (i) a point source in an axisymmetrical two‐dimensional domain, (ii) a line source in a planar two‐dimensional domain, or (iii) a point source in a fully three‐dimensional domain. Results indicated that SDI systems can be accurately described using an axisymmetrical two‐dimensional model only before wetting patterns start to overlap, and a planar two‐dimensional model only after full merging of the wetting fronts from neighboring emitters. A fully three‐dimensional model appears to be required for describing subsurface drip irrigation processes in their entirety.

No abstract

Abstract. Water management substantially alters natural regimes of streamflow through modifying retention time and water exchanges among different components of the terrestrial water cycle. Accurate simulation of water cycling in intensively managed watersheds, such as the Yakima River basin (YRB) in the Pacific Northwest of the US, faces challenges in reliably characterizing influences of management practices (e.g., reservoir operation and cropland irrigation) on the watershed hydrology. Using the Soil and Water Assessment Tool (SWAT) model, we evaluated streamflow simulations in the YRB based on different reservoir operation and irrigation schemes. Simulated streamflow with the reservoir operation scheme optimized by the RiverWare model better reproduced measured streamflow than the simulation using the default SWAT reservoir operation scheme. Scenarios with irrigation practices demonstrated higher water losses through evapotranspiration (ET) and matched benchmark data better than the scenario that only considered reservoir operations. Results of this study highlight the importance of reliably representing reservoir operations and irrigation management for credible modeling of watershed hydrology. The methods and findings presented here hold promise to enhance water resources assessment that can be applied to other intensively managed watersheds.

This study introduces the California Food-Energy-Water System (CALFEWS) simulation model to describe the integrated, multi-sector dynamics that emerge from the coordinated management of surface and groundwater supplies throughout California's Central Valley. The CALFEWS simulation framework links the operation of state-wide, interbasin transfer projects (i.e., State Water Project, Central Valley Project) with coordinated water management strategies abstracted to the scale of irrigation/water districts.This study contributes a historic baseline (October 1996 -September 2016) evaluation of the model's performance against observations, including reservoir storage, inter-basin transfers, environmental endpoints, and groundwater banking accounts. State-aware, rules-based representations of critical component systems enable CALFEWS to simulate adaptive management responses to alternative climate, infrastructure, and regulatory scenarios. Moreover, CALFEWS has been designed to maintain interoperability with electric power dispatch and agricultural production models. As such, CALFEWS provides a platform to evaluate internally consistent scenarios for the integrated management of water supply, energy generation, and food production.

Adaptation to a changing climate is critical to address future global food and water security challenges. While these challenges are global, successful adaptation strategies are often generated at regional scales; therefore, regional‐scale studies are critical to inform adaptation decision making. While climate change affects both water supply and demand, water demand is relatively understudied, especially at regional scales. The goal of this work is to address this gap, and characterize the direct impacts of near‐term (for the 2030s) climate change and elevated CO2 levels on regional‐scale crop yields and irrigation demands for the Columbia River basin (CRB). This question is addressed through a coupled crop‐hydrology model that accounts for site‐specific and crop‐specific characteristics that control regional‐scale response to climate change. The overall near‐term outlook for agricultural production in the CRB is largely positive, with yield increases for most crops and small overall increases in irrigation demand. However, there are crop‐specific and location‐specific negative impacts as well, and the aggregate regional response of irrigation demands to climate change is highly sensitive to the spatial crop mix. Low‐value pasture/hay varieties of crops—typically not considered in climate change assessments—play a significant role in determining the regional response of irrigation demands to climate change, and thus cannot be overlooked. While, the overall near‐term outlook for agriculture in the region is largely positive, there may be potential for a negative outlook further into the future, and it is important to consider this in long‐term planning.

As managers of agricultural and natural resources are confronted with uncertainties in global change impacts, the complexities associated with the interconnected cycling of nitrogen, carbon, and water present daunting management challenges. Existing models provide detailed information on specific sub-systems (e.g., land, air, water, and economics). An increasing awareness of the unintended consequences of management decisions resulting from interconnectedness of these sub-systems, however, necessitates coupled regional earth system models (EaSMs). Decision makers' needs and priorities can be integrated into the model design and development processes to enhance decision-making relevance and "usability" of EaSMs. BioEarth is a research initiative currently under development with a focus on the U.S. Pacific Northwest region that explores the coupling of multiple stand-alone EaSMs to generate usable information for resource decision-making. Direct engagement between model developers and non-academic stakeholders involved in resource and environmental management decisions throughout the model development process is a critical component of this effort. BioEarth utilizes a bottom-up approach for its land surface model that preserves fine spatialscale sensitivities and lateral hydrologic connectivity, which makes it unique among many regional EaSMs. This paper describes the BioEarth initiative and highlights opportunities and challenges associated with coupling multiple stand-alone models to generate usable information for agricultural and natural resource decision-making.

Abstract. Food supply is affected by a complex nexus of land, atmosphere, and human processes, including short- and long-term stressors (e.g., drought and climate change, respectively). A simulation platform that captures these complex elements can be used to inform policy and best management practices to promote sustainable agriculture. We have developed a tightly coupled framework using the macroscale variable infiltration capacity (VIC) hydrologic model and the CropSyst agricultural model. A mechanistic irrigation module was also developed for inclusion in this framework. Because VIC–CropSyst combines two widely used and mechanistic models (for crop phenology, growth, management, and macroscale hydrology), it can provide realistic and hydrologically consistent simulations of water availability, crop water requirements for irrigation, and agricultural productivity for both irrigated and dryland systems. This allows VIC–CropSyst to provide managers and decision makers with reliable information on regional water stresses and their impacts on food production. Additionally, VIC–CropSyst is being used in conjunction with socioeconomic models, river system models, and atmospheric models to simulate feedback processes between regional water availability, agricultural water management decisions, and land–atmosphere interactions. The performance of VIC–CropSyst was evaluated on both regional (over the US Pacific Northwest) and point scales. Point-scale evaluation involved using two flux tower sites located in agricultural fields in the US (Nebraska and Illinois). The agreement between recorded and simulated evapotranspiration (ET), applied irrigation water, soil moisture, leaf area index (LAI), and yield indicated that, although the model is intended to work on regional scales, it also captures field-scale processes in agricultural areas.

No abstract