No abstract

There have been a number of case reports and small clinical trials reporting promising outcomes of Janus Kinase (JAK) inhibitors tofacitinib, ruxolitinib and baricitinib for alopecia areata (AA). The majority of the literature to date is based on small volume data, with a lack of definitive evidence or guidelines. To determine the expected response of AA to JAK inhibitor therapy and factors which influence response and recurrence rates. A systematic review and meta-analysis was performed according to PRISMA guidelines. From 30 studies and 289 cases, there were 72.4% responders, good responders 45.7% and partial responders 21.4%. Mean time to initial hair growth was 2.2 AE 6.7 months, and time to complete hair regrowth was 6.7 AE 2.2 months. All 37 recurrences occurred when treatment was ceased after 2.7 months. Oral route was significantly associated with response to treatment compared to topical therapy. No difference was found between paediatric and adult cases in proportion of responses. There is promising low-quality evidence regarding the effectiveness of JAK inhibitors in AA. Future large-sized randomized studies are required to confirm findings.

No abstract

No abstract

ALIF and TLIF appear to have similar success and clinical outcomes, with different complication profiles. ALIF may be associated with superior restoration of disk height and lordosis, but requires further validation in future studies.

OBJECTIVE There has been a recent renewed interest in the use and potential applications of 3D printing in the assistance of surgical planning and the development of personalized prostheses. There have been few reports on the use of 3D printing for implants designed to be used in complex spinal surgery. METHODS The authors report 2 cases in which 3D printing was used for surgical planning as a preoperative mold, and for a custom-designed titanium prosthesis: one patient with a C-1/C-2 chordoma who underwent tumor resection and vertebral reconstruction, and another patient with a custom-designed titanium anterior fusion cage for an unusual congenital spinal deformity. RESULTS In both presented cases, the custom-designed and custom-built implants were easily slotted into position, which facilitated the surgery and shortened the procedure time, avoiding further complex reconstruction such as harvesting rib or fibular grafts and fashioning these grafts intraoperatively to fit the defect. Radiological follow-up for both cases demonstrated successful fusion at 9 and 12 months, respectively. CONCLUSIONS These cases demonstrate the feasibility of the use of 3D modeling and printing to develop personalized prostheses and can ease the difficulty of complex spinal surgery. Possible future directions of research include the combination of 3D-printed implants and biologics, as well as the development of bioceramic composites and custom implants for load-bearing purposes.

Three-dimensional printing (3DP), also known as "Additive Manufacturing", is a rapidly growing industry, particularly in the area of spinal surgery. Given the complex anatomy of the spine and delicate nature of surrounding structures, 3DP has the potential to aid surgical planning and procedural accuracy. We perform a systematic review of current literature on the applications of 3DP in spinal surgery. Six electronic databases were searched for original published studies reporting cases or outcomes for 3DP surgical models, guides or implants for spinal surgery. The findings of these studies were synthesized and summarized. These searches returned a combined 2,411 articles. Of these, 54 were included in this review. 3DP is currently used for surgical planning, intra-operative surgical guides, customised prostheses as well as "Off-the-Shelf" implants. The technology has the potential for enhanced implant properties, as well as decreased surgical time and better patient outcomes. The majority of the data thus far is from low-quality studies with inherent biases linked with the excitement of a new field. As the body of literature continues to expand, larger scale studies to evaluate advantages and disadvantages, and longer-term follow up will enhance our knowledge of the effect 3DP has in spinal surgery. In addition, issues such as financial impact, time to design and print, materials selection and bio-printing will evolve as this rapidly expanding field matures.

No abstract