Abstract-The development of microstrip filters has been in great demand due to the rapid growth of wireless communication systems in this decade. Quasi-elliptic response filters are very popular in communication systems because of their high selectivity, which is introduced by a pair of transmission zeros. A number of ways of implementing the quasi-elliptic response filter on microstrip have been studied over the last two decades, i.e., the cascaded quadruplet filter, canonical filter, and extracted-pole filter. However, there is very little information in the literature giving the design details for microstrip extracted-pole filters. In this paper, design equations of the extracted-pole filter for microstrip are reviewed. A new class of microstrip filter is also presented here. This class of filter will have a quasi-elliptic function response and at the same time linear phase in the passband. The linear phase of the filter is introduced by an in-phase cross coupling, while the transmission zero is realized using an extracted-pole technique. Experimental results, together with a theoretical comparison between the group delay of this design, and the conventional quasi-elliptic six-pole filter are also presented.Index Terms-Author, please supply index terms. E-mail keywords@ieee.org for information.
Dual-mode square patch resonator is well known in the design of a single band quasi-elliptic bandpass filter response. Here, the dual-mode square patch resonator is employed to achieve a dualband bandpass filter. A 6 pole dual-band bandpass filter response with 3 poles at each passband will be presented. The dual-band filter also exhibits a transmission zero between the two passbands. A detailed discussion on the design procedure together with the simulation and experimental results will be presented.
Abstract-A Substrate integrated waveguide bandpass filter is presented with a novel CPW-to-SIW transition at both the input and output ports which also served as the input and output couplings into the filter. The CPW-to-SIW transition structures presented here exploited the step impedance between the 50 ohms input/output feedline and the transition to control the input/output couplings of the filter. The SIW filter is also shown to have very minimum milling or etching requirement which reduces the fabrication error. The proposed SIW filter has been validated experimentally and results presented. The results show that a simulated return loss of 15 dB and an initial measured return loss of 16 dB were achieved. An improved measured return loss of 22 dB was later achieved after some tuining adjustments were performed on the filter input and output couplings. A minimum insertion loss of 1.3 dB was also achieved across the band.
This paper presents a substrate integrated waveguide (SIW) Chebyshev bandpass filter using the low cost, commercially available printed circuit board (PCB) technology. The detailed design procedure beginning from the normalized Chebyshev lowpass filter, to the final optimized SIW bandpass filter is presented. The test filter having a 4% fractional bandwidth centered at 1.684 GHz was fabricated on a 1.27 mm thick, Rogers RT/Duroid 6010LM substrate with a 10.8 dielectric constant. The design has also been experimentally validated and results presented. The simulation and measurement responses of the filter show good agreement with a low insertion loss of 1.3 dB. The simulated and the measured return losses of about 15 dB and 16 dB respectively, were achieved across the filter passband.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.