No abstract

No abstract

Although fusion of somatic cells with embryonic stem (ES) cells has been shown to induce reprogramming, single-cell level details of the transitory phenotypic changes that occur during fusion-based reprogramming are still lacking. Our group previously reported on the technique of one-to-one electrofusion via micro-slits in a microfluidic platform. In this study, we focused on developing a novel air-lock patterning technique for creating localized adhesion zones around the micro-slits for cell localization and real-time imaging of post fusion events with a single-cell resolution. Mouse embryonic fibroblasts (MEF) were fused individually with mouse ES cells using a polydimethylsiloxane (PDMS) fusion chip consisting of two feeder channels with a separating wall containing an array of micro-slits (slit width ∼3 μm) at a regular spacing. ES cells and MEFs were introduced separately into the channels, juxtaposed on the micro-slits by dielectrophoresis and fused one-to-one by a pulse voltage. To localize fused cells for on-chip culture and time-lapse microscopy, we implemented a two-step approach of air-lock bovine serum albumin patterning and Matrigel coating to create localized adhesion areas around the micro-slits. As a result of time-lapse imaging, we could determine that cell division occurs within 24 h after fusion, much earlier than the 2–3 days reported by earlier studies. Remarkably, Oct4-GFP (Green Fluorescent Protein) was confirmed after 25 h of fusion and thereafter stably expressed by daughter cells of fused cells. Thus, integrated into our high-yield electrofusion platform, the technique of air-lock assisted adhesion patterning enables a single-cell level tracking of fused cells to highlight cell-level dynamics during fusion-based reprogramming.

Mechanical methods for inducing differentiation and directing lineage specification will be instrumental in the application of pluripotent stem cells. Here, we demonstrate that minimization of cell-substrate adhesion can initiate and direct the differentiation of human pluripotent stem cells (hiPSCs) into cyst-forming trophoblast lineage cells (TLCs) without stimulation with cytokines or small molecules. To precisely control cell-substrate adhesion area, we developed a novel culture method where cells are cultured on microstructured mesh sheets suspended in a culture medium such that cells on mesh are completely out of contact with the culture dish. We used microfabricated mesh sheets that consisted of open meshes (100∼200 μm in pitch) with narrow mesh strands (3-5 μm in width) to provide support for initial cell attachment and growth. We demonstrate that minimization of cell adhesion area achieved by this culture method can trigger a sequence of morphogenetic transformations that begin with individual hiPSCs attached on the mesh strands proliferating to form cell sheets by self-assembly organization and ultimately differentiating after 10-15 days of mesh culture to generate spherical cysts that secreted human chorionic gonadotropin (hCG) hormone and expressed caudal-related homeobox 2 factor (CDX2), a specific marker of trophoblast lineage. Thus, this study demonstrates a simple and direct mechanical approach to induce trophoblast differentiation and generate cysts for application in the study of early human embryogenesis and drug development and screening.

No abstract

Cellular dynamics leading to the formation of the trophectoderm in humans remain poorly understood owing to limited accessibility to human embryos for research into early human embryogenesis. Compared to animal models, organoids formed by self-organization of stem cells in vitro may provide better insights into differentiation and complex morphogenetic processes occurring during early human embryogenesis. Here we demonstrate that modulating the cell culture microenvironment alone can trigger self-organization of human induced pluripotent stem cells (hiPSCs) to yield trophectoderm-mimicking cysts without chemical induction. To modulate the adhesion microenvironment, we used the mesh culture technique recently developed by our group, which involves culturing hiPSCs on suspended micro-structured meshes with limited surface area for cell adhesion. We show that this adhesion-restriction strategy can trigger a two-stage self-organization of hiPSCs; first into stem cell sheets, which express pluripotency signatures until around day 8-10, then into spherical cysts following differentiation and self-organization of the sheet-forming cells. Detailed morphological analysis using immunofluorescence microscopy with both confocal and two-photon microscopes revealed the anatomy of the cysts as consisting of a squamous epithelial wall richly expressing E-cadherin and CDX2. We also confirmed that the cysts exhibit a polarized morphology with basal protrusions, which show migratory behavior when anchored. Together, our results point to the formation of cysts which morphologically resemble the trophectoderm at the late-stage blastocyst. Thus, the mesh culture microenvironment can initiate self-organization of hiPSCs into trophectoderm-mimicking cysts as organoids with potential application in the study of early embryogenesis and also in drug development.

Chromatin folding shows spatio-temporal fluctuations in living undifferentiated cells, but fixed spatial heterogeneity in differentiated cells. However, little is known about variation in folding stability along the chromatin fibres during differentiation. In addition, effective methods to investigate folding stability at the single cell level are lacking. In the present study, we developed a microfluidic device that enables non-destructive isolation of chromosomes from single mammalian cells as well as real-time microscopic monitoring of the partial unfolding and stretching of individual chromosomes with increasing salt concentrations under a gentle flow. Using this device, we compared the folding stability of chromosomes between non-differentiated and differentiated cells and found that the salt concentration which induces the chromosome unfolding was lower (≤500 mM NaCl) for chromosomes derived from undifferentiated cells, suggesting that the chromatin folding stability of these cells is lower than that of differentiated cells. In addition, individual unfolded chromosomes, i.e., chromatin fibres, were stretched to 150–800 µm non-destructively under 750 mM NaCl and showed distributions of highly/less folded regions along the fibres. Thus, our technique can provide insights into the aspects of chromatin folding that influence the epigenetic control of cell differentiation.

Cell migration is fundamental to various physiological processes, including metastasis, wound healing and tissue development. The complex processes involved in cell migration; polymerization, adhesion, and retraction, are mediated by highly orchestrated structure-function interactions that occur within the actin cytoskeletal structure. Thus understanding how migrating cells regulate the global dynamics of their cytoskeletal components, which result from rather localized protein-protein interactions, is fundamental to elucidating the mechanisms of cell motility. The objective of this review is to explore the mechanical regulation of actin network dynamics in migrating cells, and to discuss its regulatory role in cell migration. Specifically, we examine the various mechanical forces involved in cell migration, and how they couple with biomechanical factors to spatiotemporally regulate the dynamics of the actin cytoskeleton during cell motility. Two aspects of actin network dynamics are addressed, namely, network turnover by polymerization and depolymerization, and network flow resulting from actomyosin activity. We begin by highlighting the fundamental features of actin network dynamics in migrating cells. We then examine the coupling relationship between actin network flow and traction forces, as well as the mechanism underlying the regulation of traction forces by actin network flow. Finally, we integrate the various motility processes into a mechanical pathway in order to elucidate the importance of mechanical regulation of actin network dynamics to cell migration.In fact, front-rear polarity is an important initial step during cell migration.Collectively, the events of cell migration are realized by multiscale interactions at different cellular modules, and they involve the interplay of diverse mechanical factors, both internal and external in origin. As such, they need to be carefully orchestrated in both time and space, in order to achieve robust whole-cell movement that is responsive to the biomechanical and biochemical environment of the cell. Although intensive research over the last few decades has shed light into the molecular players and pathways involved in cell migration, precisely how cells regulate the many molecular and structural dynamics that take place at different cellular modules during cell movement is less understood (2) . Moreover, although it is increasingly becoming clear, thanks to studies on cell mechanobiology, that coupling interactions between mechanical and biochemical factors play crucial roles in the regulation of various motility processes, a full understanding of the mechanisms underlying these interactions is yet to be achieved.This review focuses on the mechanical regulation of the actin cytoskeleton, and explores the nature and roles of mechanical forces involved in the migration processes. Specifically, we examine how mechanical factors, including network strain and actomyosin tension are generated, and how they contribute to the regulation of actin network dynamics during c...