Abstract. A large data set containing coincident in situ chlorophyll and remote sensing reflectance measurements was used to evaluate the accuracy, precision, and suitability of a wide variety of ocean color chlorophyll algorithms for use by SeaWiFS (Sea-viewing Wide Field-of-view Sensor). The radiance-chlorophyll data were assembled from various sources during the SeaWiFS Bio-optical Algorithm Mini-Workshop (SeaBAM) and is composed of 919 stations encompassing chlorophyll concentrations between 0.019 and 32.79/•g L -1.Most of the observations are from Case I nonpolar waters, and --•20 observations are from more turbid coastal waters. A variety of statistical and graphical criteria were used to evaluate the performances of 2 semianalytic and 15 empirical chlorophyll/pigment algorithms subjected to the SeaBAM data. The empirical algorithms generally performed better than the semianalytic. Cubic polynomial formulations were generally superior to other kinds of equations. Empirical algorithms with increasing complexity (number of coefficients and wavebands), were calibrated to the SeaBAM data, and evaluated to illustrate the relative merits of different formulations. The ocean chlorophyll 2 algorithm (OC2), a modified cubic polynomial (MCP) function which uses Rrs490/Rrs555, well simulates the sigmoidal pattern evident between log-transformed radiance ratios and chlorophyll, and has been chosen as the at-launch SeaWiFS operational chlorophyll a algorithm. Improved performance was obtained using the ocean chlorophyll 4 algorithm (OC4), a four-band (443, 490, 510, 555 nm), maximum band ratio formulation. This maximum band ratio (MBR) is a new approach in empirical ocean color algorithms and has the potential advantage of maintaining the highest possible satellite sensor signal'noise ratio over a 3-orders-of-magnitude range in chlorophyll concentration. IntroductionThe influence of phytoplankton on the color of seawater has been studied for several decades. It is well understood that chlorophyll a, the primary photosynthetic pigment in phytoplankton, absorbs relatively more blue and red light than green, and the spectrum of backscattered sunlight or color of ocean water progressively shifts from deep blue to green as the concentration of phytoplankton increases [e.g.

For open ocean and coastal waters, a multiband quasi-analytical algorithm is developed to retrieve absorption and backscattering coefficients, as well as absorption coefficients of phytoplankton pigments and gelbstoff. This algorithm is based on remote-sensing reflectance models derived from the radiative transfer equation, and values of total absorption and backscattering coefficients are analytically calculated from values of remote-sensing reflectance. In the calculation of total absorption coefficient, no spectral models for pigment and gelbstoff absorption coefficients are used. Actually those absorption coefficients are spectrally decomposed from the derived total absorption coefficient in a separate calculation. The algorithm is easy to understand and simple to implement. It can be applied to data from past and current satellite sensors, as well as to data from hyperspectral sensors. There are only limited empirical relationships involved in the algorithm, and they are for less important properties, which implies that the concept and details of the algorithm could be applied to many data for oceanic observations. The algorithm is applied to simulated data and field data, both non-case1, to test its performance, and the results are quite promising. More independent tests with field-measured data are desired to validate and improve this algorithm.

In earlier studies of passive remote sensing of shallow-water bathymetry, bottom depths were usually derived by empirical regression. This approach provides rapid data processing, but it requires knowledge of a few true depths for the regression parameters to be determined, and it cannot reveal in-water constituents. In this study a newly developed hyperspectral, remote-sensing reflectance model for shallow water is applied to data from computer simulations and field measurements. In the process, a remote-sensing reflectance spectrum is modeled by a set of values of absorption, backscattering, bottom albedo, and bottom depth; then it is compared with the spectrum from measurements. The difference between the two spectral curves is minimized by adjusting the model values in a predictor-corrector scheme. No information in addition to the measured reflectance is required. When the difference reaches a minimum, or the set of variables is optimized, absorption coefficients and bottom depths along with other properties are derived simultaneously. For computer-simulated data at a wind speed of 5 m/s the retrieval error was 5.3% for depths ranging from 2.0 to 20.0 m and 7.0% for total absorption coefficients at 440 nm ranging from 0.04 to 0.24 m(-1). At a wind speed of 10 m/s the errors were 5.1% for depth and 6.3% for total absorption at 440 nm. For field data with depths ranging from 0.8 to 25.0 m the difference was 10.9% (R2 = 0.96, N = 37) between inversion-derived and field-measured depth values and just 8.1% (N = 33) for depths greater than 2.0 m. These results suggest that the model and the method used in this study, which do not require in situ calibration measurements, perform very well in retrieving in-water optical properties and bottom depths from above-surface hyperspectral measurements.

A simple spectral atmospheric radiative transfer model specific for oceanographic applications begins with spectral extraterrestrial solar u-radiance corrected for earth-sun orbital distance. Irradiance is then attenuated in passing through the atmosphere by Rayleigh scattering, ozone, oxygen, and water vapor absorption, and marine aerosol scattering and absorption, and is finally reduced by reflectance at the air-sea interface. The model is an extension of the continental aerosol model of Bird and Riordan, modified to include maritime aerosol properties, irradiance transmittance through the air-sea interface, and atmospheric absorption at very high spectral resolution (1 nm). Atmospheric optical constituents and the surface reflectance are functions of the local meteorological conditions, imparting flexibility to the model to reproduce the spectral ii-radiance under a variety of maritime atmospheres. The model computes ii-radiance at or just below the ocean surface at high spectral resolution in the range 350-700 nm, i.e. within the range required for photosynthetically available radiation (PAR) calculations. It agrees spectrally with observed surface spectral irradiances to within f 6.6% (rms) and as integrated PAR to within + 5.1%. The computed spectral u-radiance is useful as an input to bio-optical models in the ocean, to phytoplankton growth and primary production models, and in remote-sensing applications.

For analytical or semianalytical retrieval of shallow-water bathymetry and/or optical properties of the water column from remote sensing, the contribution to the remotely sensed signal from the water column has to be separated from that of the bottom. The mathematical separation involves three diffuse attenuation coefficients: one for the downwelling irradiance (K(d)), one for the upwelling radiance of the water column (K(u)(C)), and one for the upwelling radiance from bottom reflection (K(u)(B)). Because of the differences in photon origination and path lengths, these three coefficients in general are not equal, although their equality has been assumed in many previous studies. By use of the Hydrolight radiative-transfer numerical model with a particle phase function typical of coastal waters, the remote-sensing reflectance above (R(rs)) and below (r(rs)) the surface is calculated for various combinations of optical properties, bottom albedos, bottom depths, and solar zenith angles. A semianalytical (SA) model for r(rs) of shallow waters is then developed, in which the diffuse attenuation coefficients are explicitly expressed as functions of in-water absorption (a) and backscattering (b(b)). For remote-sensing inversion, parameters connecting R(rs) and r(rs) are also derived. It is found that r(rs) values determined by the SA model agree well with the exact values computed by Hydrolight (~3% error), even for Hydrolight r(rs) values calculated with different particle phase functions. The Hydrolight calculations included b(b)/a values as high as 1.5 to simulate high-turbidity situations that are occasionally found in coastal regions.

Marine humic and fulvic acids were concentrated from about 1,400 liters of seawater from the Gulf of Mexico, and specific absorption coefficients were measured for each from 240 to 675 nm. Spectral absorption coefficients were then calculated for Gulf of Mexico stations where earlier data on humic and fulvic acid concentrations were available. Marine humic and fulvic acid values have low molecular weights consistent with extrapolations from soil-derived curves of their specific absorption coefficients vs. molecular weight. Marine fulvic and humic acids appear to account for most if not all water color or GelbstoK in the offshore regions of the Gulf of Mexico. Based on a remote-sensing reflectance model, it appears that the increase in the Gelbstoff: chlorophyll ratio for waters adjacent to and downstream from regions 'of high primary productivity accounts for much of the deviation found for such waters from the global chlorophyll algorithm of the Coastal Zone Color Scanner.

(1) high photoprotective pigment to chlorophyll ratio and low self-shading, which for brevity, we designate as "unpackaged"; (2) low photoprotective pigment to chlorophyll ratio and high selfshading, which we designate as "packaged"; and (3) a transitional or global-average type. These domains can be identified from space by comparing sea-surface temperature to nitrogendepletion temperatures for each domain. Algorithm errors of more than 45 % are reduced to errors of less than 30 % with this approach, with the greatest effect occurring at the eastern and polar boundaries of the basins.

Dissolved and suspended materials in the ocean modify the in-water light field by absorbing and scattering photons. Direct measurement of inherent optical properties of individual optical constituents is difficult since the constituents themselves cannot all be separated. A model was developed to resolve in situ phytoplankton absorption from a measured in situ total absorption spectrum which includes water, dissolved organics, particulate detritus, and phytoplankton. The model was tested on a set of absorption spectra obtained from the productive waters around the San Juan Islands, Washington. Results indicate that the model can predict the spectral shape of phytoplankton absorption (rz > 0.9) and total photon absorption by phytoplankton with ~27% error. Total photon absorption can be used to estimate phytoplankton absorption of light energy for improved primary production predictions, given submarine light field measurements or model calculations. Although developed for high chlorophyll waters, the model parameters are easily modified for vario&Casc 1 optical domains.