1. In Mg(2+)-free external solution, rat cortical neurons in cultured networks entered a stable firing mode, consisting of regular bursts of action potentials superimposed on long-lasting depolarizations. The average separation between bursts varied from culture to culture, but was usually between 5 and 20 s. The distribution of burst intervals followed a Gaussian or normal distribution, with a standard deviation of typically 10% of the average burst period. 2. A gradually depolarizing pacemaker potential was never observed between bursts, but the threshold for action potentials during the quiescent phase was > or = 10 mV above the resting potential. No progressive change in conductance or excitability was observed during the quiescent period. Intracellular stimulation of action potentials did not reproduce the long-lasting depolarization. 3. Switching from current clamp to voltage clamp at the resting potential revealed large postsynaptic currents, mainly excitatory but with a small inhibitory component, at the same phase and frequency as the spike bursts, showing that periodic synaptic input is responsible for the burst-depolarizations. The current could be eliminated by local application of 2-amino-5-phosphonovaleric acid (APV) or 6-cyano-7-nitroquinoxaline-2,3-dione (CNQX) to the postsynaptic cell. In the presence of tetrodotoxin, irregular miniature excitatory postsynaptic currents were observed. 4. A fluorescent calcium indicator (fluo-3, 100 microM) was included in the whole-cell pipette solution, to allow simultaneous electrical and calcium measurements in the same cell. In current clamp, transient intracellular calcium increases were found, which were synchronized to the spike bursts. The Ca2+ rise lasted as long as the action potential burst, and was followed by an exponential decay considerably slower than that of the membrane potential. Calcium transients disappeared during voltage clamp at the resting potential, suggesting that calcium influx through voltage-dependent calcium channels greatly exceeds that through synaptic channels. 5. Multisite Ca2+ recording, after loading with fluo-3 acetoxymethyl (AM) ester, revealed that the onsets of burst-related calcium transients were synchronized in all active cells of each view-field, to within approximately 20 ms. Occasionally, secondary rhythms were observed in which only a subset of cells participated. The times to peak and the decay times of calcium transients varied among synchronized cells. 6. The pharmacology of the burst-related calcium transients was investigated by bath application of a variety of compounds.(ABSTRACT TRUNCATED AT 400 WORDS)

The capability for multisite stimulation is one of the biggest potential advantages of microelectrode arrays (MEAs). There remain, however, several technical problems which have hindered the development of a practical stimulation system. An important design goal is to allow programmable multisite stimulation, which produces minimal interference with simultaneous extracellular and patch or whole cell clamp recording. Here, we describe a multisite stimulation and recording system with novel interface circuit modules, in which preamplifiers and transistor transistor logic-driven solid-state switching devices are integrated. This integration permits PC-controlled remote switching of each substrate electrode. This allows not only flexible selection of stimulation sites, but also rapid switching of the selected sites between stimulation and recording, within 1.2 ms. This allowed almost continuous monitoring of extracellular signals at all the substrate-embedded electrodes, including those used for stimulation. In addition, the vibration-free solid-state switching made it possible to record whole-cell synaptic currents in one neuron, evoked from multiple sites in the network. We have used this system to visualize spatial propagation patterns of evoked responses in cultured networks of cortical neurons. This MEA-based stimulation system is a useful tool for studying neuronal signal processing in biological neuronal networks, as well as the process of synaptic integration within single neurons.

Hydrogel-based, molecular permeable electronic devices are considered to be promising for electrical stimulation and recording of living tissues, either in vivo or in vitro. This study reports the fabrication of the first hydrogel-based devices that remain highly electrically conductive under substantial stretch and bending. Using a simple technique involving a combination of chemical polymerization and electropolymerization of poly (3,4-ethylenedioxythiophene) (PEDOT), a tight bonding of a conductive composite of PEDOT and polyurethane (PU) to an elastic double-network hydrogel is achieved to make fully organic PEDOT/PU-hydrogel hybrids. Their response to repeated bending, mechanical stretching, hydration-dessication cycles, storage in aqueous condition for up to 6 months, and autoclaving is assessed, demonstrating excellent stability, without any mechanical or electrical damage. The hybrids exhibit a high electrical conductivity of up to 120 S cm(-1) at 100% elongation. The adhesion, proliferation, and differentiation of neural and muscle cells cultured on these hybrids are demonstrated, as well as the fabrication of 3D hybrids, advancing the field of tissue engineering with integrated electronics.

Electrode materials for recording biomedical signals, such as electrocardiography (ECG), electroencephalography (EEG) and evoked potentials data, are expected to be soft, hydrophilic and electroconductive to minimize the stress imposed on living tissue, especially during long-term monitoring. We have developed and characterized string-shaped electrodes made from conductive polymer with silk fiber bundles (thread), which offer a new biocompatible stress free interface with living tissue in both wet and dry conditions.An electroconductive polyelectrolyte, poly(3,4-ethylenedioxythiophene) -poly(styrenesulfonate) (PEDOT-PSS) was electrochemically combined with silk thread made from natural Bombyx mori. The polymer composite 280 µm thread exhibited a conductivity of 0.00117 S/cm (which corresponds to a DC resistance of 2.62 Mohm/cm). The addition of glycerol to the PEDOT-PSS silk thread improved the conductivity to 0.102 S/cm (20.6 kohm/cm). The wettability of PEDOT-PSS was controlled with glycerol, which improved its durability in water and washing cycles. The glycerol treated PEDOT-PSS silk thread showed a tensile strength of 1000 cN in both wet and dry states. Without using any electrolytes, pastes or solutions, the thread directly collects electrical signals from living tissue and transmits them through metal cables. ECG, EEG, and sensory evoked potential (SEP) signals were recorded from experimental animals by using this thread placed on the skin. PEDOT-PSS silk glycerol composite thread offers a new class of biocompatible electrodes in the field of biomedical and health promotion that does not induce stress in the subjects.

No abstract