No abstract

Although femoroacetabular impingement (FAI) has recently been considered to be one of the causes of osteoarthritis (OA) of the hip, the exact pathogeneses and incidence of FAI and primary OA are unknown. The purposes of this study were to investigate the causes of hip OA in Japan and to clarify the prevalence of FAI in patients with hip OA. We retrospectively investigated 817 consecutive patients (946 hips) who underwent primary surgery with the diagnosis of OA of the hip. Clinical recordings and preoperative radiographs were evaluated to determine the cause of OA. There were 17 hips who had primary OA, of which six hips were determined to be FAI positive. The remaining 11 cases without FAI had primary OA of unknown aetiology. Our study has revealed that most hip OA cases were caused by developmental dysplasia of the hip. We only found a few cases (0.6%) with FAI in Japan.

The existing methods of assessing limb lengthening during total hip arthroplasty (THA) are prone to error because the measurements are not parallel to the limb lengthening axis. In order to address this, we designed a caliper to estimate limb lengthening during THA and evaluated its accuracy compared with our previous device, the straight caliper. Limb lengths were measured in 100 patients. The L-shaped caliper was used in 50 cases and the straight caliper in 50. The correlation between intra-operative and post-operative radiographic measurements was significantly improved using the L-shaped device (p < 0.0001, r = 0.934). This method was extremely accurate in predicting changes in limb length due to surgery.

We retrospectively reviewed 68 hips in 62 patients with acetabular dysplasia who underwent curved periacetabular osteotomy. Among the 68 hips, 33 had acetabular retroversion (retroversion group) and 35 had anteversion (control group) preoperatively. All hips were evaluated according to the Harris hip score. Radiographic evaluations of acetabular retroversion and posterior wall deficiency were based on the cross-over sign and posterior wall sign, respectively. The clinical scores of the two groups at the final follow-up were similar. In the retroversion group, 12 hips had anteverted acetabulum postoperatively. The posterior wall sign disappeared in these hips, but remained in 21 hips with retroverted acetabulum postoperatively. Among the 21 hips with retroverted acetabulum, posterior osteoarthritis of the hip developed postoperatively in five hips. When performing corrective osteotomy for a dysplastic hip with acetabular retroversion, it is important to correct the acetabular retroversion to prevent posterior osteoarthritis of the hip due to posterior wall deficiency.

No abstract

Background We believe a curved periacetabular osteotomy is indicated for treatment of severe dysplastic hips with center-edge angles less than 0°,

In this study, interleukin-6 (IL-6), C-reactive protein (CRP), and haemoglobin levels were evaluated to compare the degree of surgical invasion between mini and standard incisions in total hip arthroplasty (THA). Sixtytwo patients admitted for primary cementless THA were enrolled in this randomised study. The patients were allocated to have surgery through either a mini incision of <10 cm or a standard incision of 15 cm. In each group, inflammatory responses were evaluated by IL-6, CRP, and haemoglobin levels before operation and one day after operation. Significant differences were not found in IL-

BackgroundIncreasing the porosity of an antibiotic-loaded cement spacer increases the antibiotic elution, but the correlation between porosity and antibiotic elution is not well documented. The purposes of this study was to attempt new porosity-increasing methods and to investigate the correlation between antibiotic elution and both total and surface porosity.Materials and methodsFive types of antibiotic-loaded bone cement (ALBC) using 2 g cefazolin and 40 g cement were prepared. Other than manual mixing, hydrogen peroxide was used as a foaming agent and a mixing drill piece was used as a mechanical device to try to induce porosity when mixing the cement. Elution of antibiotic into phosphate-buffered saline was measured from 1 h to 1 week. Surface porosity was calculated from density values which were measured with a density kit and an electronic balance, while total porosity was quantified using micro-computed tomography.ResultsWhen a mixing drill piece was used to induce porosity, we observed a significant increasin antibiotic elution compared to a manually mixed ALBC. On the other hand, hydrogen peroxide reduced the elution significantly. Mild correlation between the total amount of cluted in 1 week antibiotic elution and total porosity was observed.ConclusionsIn terms of improving elution, the mixing drill piece seemed to be efficient. A relationship between surface porosity and elution efficacy was not observed.