No abstract

The application of a Hadamard transform technique to microchip electrophoresis is described. The sample is electrokinetically injected into a separation channel and is then detected by diode laser-induced fluorometry. The sample and buffer solutions are introduced into the channel by controlling the high voltages applied to the solutions, according to a code determined by a Hadamard matrix. The S/N ratio of the signal in the electropherogram can be improved by a factor of 5 in comparison with that obtained by a conventional single-injection method, although an 8-fold improvement is theoretically predicted when a 255-order matrix is used.

A novel injection device for applying absorption spectrometry to Hadamard transform (HT) capillary electrophoresis is described. A small hole, at the center part of the capillary, functions as an inlet port for the sample. The hole is immersed in a sample solution and the end of the capillary that is usually employed for sample introduction is immersed in a buffer solution. An ultraviolet absorption detector is placed between the sample injection port and the other end of the capillary filled with a buffer solution. A high potential is continuously applied between the injection port and the end of the capillary, which allows the sample solution to be introduced into the separation capillary. By application of a higher potential modulated according to a Hadamard code between both ends of the capillary, the buffer solution is injected into the separation capillary. In some preliminary experiments, this injection device was utilized to introduce a single sample segment into a capillary. As expected, a single peak was observed in the electropherogram for a sample containing a single component. This device was then employed for multiple sample injection in HT capillary electrophoresis. An 8-fold improvement in the S/N ratio was observed when the HT technique was used, in which a 255-order of a Hadamard matrix was used, as expected from theory. The present approach was also utilized for the sensitive detection of a sample comprised of multiple components.

No abstract

The Hadamard transform (HT) technique, which permits the S/N in CE to be improved, was applied to MEKC. Multiple sample injection of fluorescent analytes according to a Hadamard code sequence was performed using an optically gated sample injection technique, in which a sample plug was produced based on photodegradation by irradiation with an intense laser beam. The capillary and reservoirs were filled with a sample solution containing buffer components and SDS as a pseudostationary phase. A preliminary study confirmed that fluorescein ion could be photobleached in the presence of SDS. The optically gated sample injection technique was then applied to multiple sample injection, based on a Hadamard matrix. The S/N in the electropherogram obtained by HT-MEKC was improved substantially compared to that obtained by a single injection method. When the technique was applied to the separation of several amino acids labeled with FITC, the S/N ratio for each amino acid was enhanced, without any evidence of degradation in separation resolution. Moreover, HT-MEKC was applied to the analysis of amino acids contained in a Japanese beverage, resulting in improved S/Ns for the amino acids.