No abstract

No abstract

Locked plating constructs were stiffer than the Ogden construct in axial loading and torsion. Although no differences in loads to failure during torsion were noted, locked plating constructs exhibited catastrophic failure not observed with the Ogden construct.

No abstract

Aseptic loosening and failure of a tibial component are recognized problems in unicompartmental knee arthroplasty (UKA). Excessive stress on the supporting cancellous bone is thought to contribute to the loosening and failure. Of factors that could influence supporting cancellous bone stresses, we focused on the inclination of a unicompartmental tibial component by analyzing the effect of coronal plane and sagittal plane inclination. Detailed geometrically accurate, three-dimensional finite element models were constructed from computed tomography (CT) data of a typical adult male proximal tibia. The material properties for the models were obtained directly from the CT data to simulate the inhomogeneous distribution of cancellous bone properties. Placing the component in slight valgus inclination in the coronal plane reduced the cancellous bone stresses. Posterior inclination in the sagittal plane caused a moderate increase in the stresses. Our results suggest that slight valgus inclination of a UKA tibial component may be preferable to varus or square inclination in the coronal plane. An excessive posterior slope of a tibial component should be avoided.

No abstract

Materials properties and design differences between these systems did not provide enough biomechanical difference to support use of either implant over the other. With this in vitro model, both implants provided adequate stability to resist physiologic loads expected during therapy in the initial postoperative period.

A sliding hip screw with an attached lateral support plate provides stability and ability to resist medial displacement of the femoral shaft similar to that seen with the IMHS.