Abstract. An Aerodyne Aerosol Mass Spectrometer (AMS) was deployed at the CENICA Supersite, during the Mexico City Metropolitan Area field study (MCMA-2003) from 31 March-4 May 2003 to investigate particle concentrations, sources, and processes. The AMS provides real time information on mass concentration and composition of the non-refractory species in particulate matter less than 1 µm (NR-PM1) with high time and size-resolution. In order to account for the refractory material in the aerosol, we also present estimates of Black Carbon (BC) using an aethalometer and an estimate of the aerosol soil component obtained from Proton-Induced X-ray Emission Spectrometry (PIXE) analysis of impactor substrates. Comparisons of AMS + BC + soil mass concentration with other collocated particle instruments (a LASAIR Optical Particle Counter, a PM2.5 Tapered Element Oscillating Microbalance (TEOM), and a PM2.5 DustTrak Aerosol Monitor) show that the AMS + BC + soil mass concentration is consistent with the total PM2.5 mass concentration during MCMA-2003 within the combined uncertainties. In Mexico City, the organic fraction of the estimated PM2.5 at CENICA represents, on average, 54.6% (standard deviation σ=10%) of the mass, with the rest consisting of inorganic compounds (mainly ammonium nitrate and sulfate/ammonium salts), BC, and soil. Inorganic compounds represent 27.5% of PM2.5 (σ=10%); BC mass concentration is about 11% (σ=4%); while soil represents about 6.9% (σ=4%). Size distributions are presented for the AMS species; they show an accumulation mode that contains mainly oxygenated organic and secondary inorganic compounds. The organic size distributions also contain a small organic particle mode that is likely indicative of fresh traffic emissions; small particle modes exist for the inorganic species as well. Evidence suggests that the organic and inorganic species are not always internally mixed, especially in the small modes. The aerosol seems to be neutralized most of the time; however, there were some periods when there was not enough ammonium to completely neutralize the nitrate, chloride and sulfate present. The diurnal cycle and size distributions of nitrate suggest local photochemical production. On the other hand, sulfate appears to be produced on a regional scale. There are indications of new particle formation and growth events when concentrations of SO2 were high. Although the sources of chloride are not clear, this species seems to condense as ammonium chloride early in the morning and to evaporate as the temperature increases and RH decreases. The total and speciated mass concentrations and diurnal cycles measured during MCMA-2003 are similar to measurements during a previous field campaign at a nearby location.

Three alternate China‐wide temperature composites covering the last 2000 years were established by combining multiple paleoclimate proxy records obtained from ice cores, tree rings, lake sediments and historical documents. Five periods of temperature variation can be identified: a warm stage in AD 0–240, a cold interval between AD 240 and 800, a return to warm conditions from AD 800–1400, including the Medieval Warm Period between AD 800–1100, the cool Little Ice Age period between 1400–1920, and the present warm stage since 1920. Regional temperature variation is found during AD 800–1100, when warm conditions occurred in Eastern China and in the northeastern Tibetan Plateau and in AD 1150–1380, when the southern Tibetan Plateau experienced a warm interval. In contrast, evidence for cool conditions during the LIA is more consistent among the proxy records. The temperature reconstructions for China and the Northern Hemisphere show good agreement over the past millennium.

Recent ice core measurements show lead concentrations increasing since 1970, suggesting new nonautomobile-related sources of Pb are becoming important worldwide (1). Developing a full understanding of the major sources of Pb and other metals is critical to controlling these emissions. During the March, 2006 MILAGRO campaign, single particle measurements in Mexico City revealed the frequent appearance of particles internally mixed with Zn, Pb, Cl, and P. Pb concentrations were as high as 1.14 µg/m 3 in PM 10 and 0.76 µg/m 3 in PM 2.5 . Real time measurements were used to select time periods of interest to perform offline analysis to obtain detailed aerosol speciation. Many Zn-rich particles had needle-like structures and were found to be composed of ZnO and/or Zn(NO 3 ) 2 · 6H 2 O. The internally mixed Pb-Zn-Cl particles represented as much as 73% of the fine mode particles (by number) in the morning hours between 2-5 am. The Pb-Zn-Cl particles were primarily in the submicrometer size range and typically mixed with elemental carbon suggesting a combustion source. The unique single particle chemical associations measured in this study closely match signatures indicative of waste incineration. Our findings also show these industrial emissions play an important role in heterogeneous processing of NO y species. Primary emissions of metal and sodium chloride particles emitted by the same source underwent heterogeneous transformations into nitrate particles as soon as photochemical production of nitric acid began each day at ∼7 am. IntroductionParticulate air pollution is correlated with increased morbidity and mortality through cardiovascular and pulmonary effects (2). Although relatively little is known about the specific chemical constituents responsible for the adverse health effects, metal-containing particles are implicated in a number of studies (3-5). The solubility of metal ions present in particles affects their mobility in the human body while their oxidation state greatly affects their toxicity (5). Other factors such as particle size and shape determine how deep into the respiratory tract a particle may travel. Smaller particles with a compact morphology penetrate deeper into the lungs where they are more likely to be retained by the body (6-8). Anthropogenic particles created by high temperature processes (e.g., combustion and ore processing) possess many of the properties responsible for adverse health effects.In urban areas, anthropogenic sources of submicron metal-containing particles are plentiful. For example, the burning of fossil fuel leads to the association of Ni and V within particles (9). Prior to 2000, tetra-ethyl-lead was used as a gasoline additive in many countries and resulted in traffic related emissions of submicron lead particles (10). In industrial areas, smelting produce particulate emissions rich in heavy metals (11). Combustion of municipal waste produces submicron particles composed of Zn, Pb, and Cl as well as numerous other metals (12). Zn and Pb are often found to be internally ...

The global presence of soot has significant effects on regional and global climate, as well as human health. Influence of soot on radiation budget, rain formation and heterogeneous chemistry, and its residence time in the atmosphere are largely dependent on its ability to interact with water. While freshly emitted soot is extremely hydrophobic, oxidation during aging causes soot to become more hydrophilic. Laboratory studies demonstrate that aged soot attracts and retains water, and can be efficiently removed from the troposphere by entrapment in existing liquid cloud droplets or by activation as cloud condensation nuclei.

Abstract. Aerosols play an important role in the atmosphere but are poorly characterized, particularly in urban areas like the Mexico City Metropolitan Area (MCMA). The chemical composition of urban particles must be known to assess their effects on the environment, and specific particulate emissions sources should be identified to establish effective pollution control standards. For these reasons, samples of particulate matter ≤2.5 µm (PM 2.5 ) were collected during the MCMA-2003 Field Campaign for elemental and multivariate analyses. Proton-Induced X-ray Emission (PIXE), ProtonElastic Scattering Analysis (PESA) and Scanning Transmission Ion Microscopy (STIM) measurements were done to determine concentrations of 19 elements from Na to Pb, hydrogen, and total mass, respectively. The most abundant elements from PIXE analysis were S, Si, K, Fe, Ca, and Al, while the major emissions sources associated with these elements were industry, wind-blown soil, and biomass burning. Wind trajectories suggest that metals associated with industrial emissions came from northern areas of the city whereas soil aerosols came from the southwest and increased in concentration during dry conditions. Elemental markers for fuel oil combustion, V and Ni, correlated with a large SO 2 plume to suggest an anthropogenic, rather than volcanic, emissions source. By subtracting major components of soil and sulfates determined by PIXE analysis from STIM total mass measurements, we estimate that approximately 50% of nonvolatile PM 2.5 consisted of carbonaceous material.

Abstract. Chemical composition, size, and mixing state of atmospheric particles are critical in determining their effects on the environment. There is growing evidence that soot aerosols play a particularly important role in both climate and human health, but still relatively little is known of their physical and chemical nature. In addition, the atmospheric residence times and removal mechanisms for soot are neither well understood nor adequately represented in regional and global climate models. To investigate the effect of locality and residence time on properties of soot and mixing state in a polluted urban environment, particles of diameter 0.2-2.0 µm were collected in the Mexico City Metropolitan Area (MCMA) during the MCMA-2003 Field Campaign from various sites within the city. Individual particle analysis by different electron microscopy methods coupled with energy dispersed x-ray spectroscopy, and secondary ionization mass spectrometry show that freshly-emitted soot particles become rapidly processed in the MCMA. Whereas fresh particulate emissions from mixed-traffic are almost entirely carbonaceous, consisting of soot aggregates with liquid coatings suggestive of unburned lubricating oil and water, ambient soot particles which have been processed for less than a few hours are heavily internally mixed, primarily with ammonium sulfate. Single particle analysis suggests that this mixing occurs through several mechanisms that require further investigation. In light of previously published results, the internally-mixed nature of processed soot particles is expected to affect heterogeneous chemistry on the soot surface, including interaction with water during wet-removal.

Between 5 and 4 thousand years ago, crippling megadroughts led to the disruption of ancient civilizations across parts of Africa and Asia, yet the extent of these climate extremes in mainland Southeast Asia (MSEA) has never been defined. This is despite archeological evidence showing a shift in human settlement patterns across the region during this period. We report evidence from stalagmite climate records indicating a major decrease of monsoon rainfall in MSEA during the mid- to late Holocene, coincident with African monsoon failure during the end of the Green Sahara. Through a set of modeling experiments, we show that reduced vegetation and increased dust loads during the Green Sahara termination shifted the Walker circulation eastward and cooled the Indian Ocean, causing a reduction in monsoon rainfall in MSEA. Our results indicate that vegetation-dust climate feedbacks from Sahara drying may have been the catalyst for societal shifts in MSEA via ocean-atmospheric teleconnections.

Abstract.A Markov Chain Monte Carlo model for integrating the observations of inorganic species with a thermodynamic equilibrium model was presented in Part I of this series. Using observations taken at three ground sites, i.e. a residential, industrial and rural site, during the MCMA-2003 campaign in Mexico City, the model is used to analyze the inorganic particle and ammonia data and to predict gas phase concentrations of nitric and hydrochloric acid. In general, the model is able to accurately predict the observed inorganic particle concentrations at all three sites. The agreement between the predicted and observed gas phase ammonia concentration is excellent. The NO z concentration calculated from the NO y , NO and NO 2 observations is of limited use in constraining the gas phase nitric acid concentration given the large uncertainties in this measure of nitric acid and additional reactive nitrogen species. Focusing on the acidic period of 9-11 April identified by , the model accurately predicts the particle phase observations during this period with the exception of the nitrate predictions after 10:00 a.m. (Central Daylight Time, CDT) on 9 April, where the model underpredicts the obserCorrespondence to: F. M. San Martini (ico@alum.mit.edu) vations by, on average, 20%. This period had a low planetary boundary layer, very high particle concentrations, and higher than expected nitrogen dioxide concentrations. For periods when the particle chloride observations are consistently above the detection limit, the model is able to both accurately predict the particle chloride mass concentrations and provide well-constrained HCl (g) concentrations. The availability of gas-phase ammonia observations helps constrain the predicted HCl (g) concentrations. When the particles are aqueous, the most likely concentrations of HCl (g) are in the sub-ppbv range. The most likely predicted concentration of HCl (g) was found to reach concentrations of order 10 ppbv if the particles are dry. Finally, the atmospheric relevance of HCl (g) is discussed in terms of its indicator properties for the possible influence of chlorine-mediated photochemistry in Mexico City.