Salicornia europaea L. grows in areas periodically flooded by salty or brackish water. It has potential economic value, because it can be used as food, forage, or biofuel, and has potential in pharmaceuticals and cosmetics. Increasing interest in S. europaea is due to its extreme salt tolerance and well growth in marginal saline soils. However, the variation in its functional traits in response to environmental conditions is still poorly studied. There are still questions regarding the optimal level of salinity for different traits. Therefore, we worked to address the question if S. europaea traits from different scales are controlled by salinity level. Based on performed pot experiment, we found that almost all traits are salinity dependent but affected in different ways. We demonstrated that morphological, biomass, and anatomical properties indicate optimum growth between 200 and 400 mM NaCl and growth limitations at 0, 800, and 1000 mM NaCl. Moreover, we found the most affected traits which include photosynthetic pigments and protein content, plant surface area, peroxidase activity, and anatomic traits related to cell shape. Our results significantly expanded the knowledge about S. europaea functional traits variation in response to salinity, which can be important for discovering regulating processes and for possible future agricultural applications.

Ba0.5La0.5Co0.5Fe0.5O3−δ was synthesized in the solid-state reaction route. The influence of ball milling parameters (such as milling media size, angular velocity, and time), pelletizing pressure, and annealing parameters on the microstructure was studied. The grain size distribution and density or specific surface area changes were investigated in each approach while the individual parameters were changed. The evaluation of BLCF synthesis parameters enables tailoring the microstructure to various applications. It was observed that with lowering the size of milling balls and increasing the angular velocity the material will be porous and thus more appropriate as electrode material in proton ceramic fuel cell or electrolyzer. An increase of time, balls diameter, and/or angular velocity of milling enables one to densify the material in case of membrane application in, e.g., as a gas sensor. The significant influence on densification has also annealing temperature increase. Applying 1200 °C during annealing leads to dense material, while at 1100 °C shows visible porosity of the product. In this work, we present the results of the BLCF synthesis parameters change allowing the selection of appropriate parameter values depending on the further application as PCCs.

No abstract

No abstract

No abstract