Enamel demineralization around orthodontic adhesive is a common esthetic concern during orthodontic treatment. The aim of this study was to prepare orthodontic adhesives containing monocalcium phosphate monohydrate (MCPM) and nisin to enable mineralizing and antibacterial actions. The physicomechanical properties and the inhibition of S. mutans growth of the adhesives with added MCPM (5, 10 wt %) and nisin (5, 10 wt %) were examined. Transbond XT (Trans) was used as the commercial comparison. The adhesive containing a low level of MCPM showed significantly higher monomer conversion (42–62%) than Trans (38%) (p < 0.05). Materials with additives showed lower monomer conversion (p < 0.05), biaxial flexural strength (p < 0.05), and shear bond strength to enamel than those of a control. Additives increased water sorption and solubility of the experimental materials. The addition of MCPM encouraged Ca and P ion release, and the precipitation of calcium phosphate at the bonding interface. The growth of S. mutans in all the groups was comparable (p > 0.05). In conclusion, experimental orthodontic adhesives with additives showed comparable conversion but lesser mechanical properties than the commercial material. The materials showed no antibacterial action, but exhibited ion release and calcium phosphate precipitation. These properties may promote remineralization of the demineralized enamel.

White spot lesions around orthodontic brackets are the major complication during fixed orthodontic treatment. This study prepared orthodontic adhesives for promoting mineral precipitation and reducing bacterial growth. Adhesives with added calcium phosphate monohydrate/Sr-bioactive glass nanoparticles (Sr/CaP) and andrographolide were prepared. The physical/mechanical and antibacterial properties of the adhesives were tested. The additives reduced the monomer conversion of the materials (62 to 47%). The addition of Sr/CaP and andrographolide increased the water sorption (from 23 to 46 μg/mm3) and water solubility (from 0.2 to 5.9 μg/mm3) but reduced the biaxial flexural strength (from 193 to 119 MPa) of the adhesives. The enamel bond strengths of the experimental adhesives (19–34 MPa) were comparable to that of the commercial material (p > 0.05). The Sr/CaP fillers promoted Ca, Sr, and P ion release and the precipitation of calcium phosphate at the debonded interface. An increase in the Sr/CaP concentration enhanced the inhibition of S. mutans by 18%, while the effect of andrographolide was not detected. The abilities of the adhesives to promote ion release, calcium phosphate precipitation, and the growth inhibition of cariogenic bacteria were expected to reduce the occurrence of white spot lesions. The additives reduced the physical/mechanical properties of the materials, but the corresponding values were within the acceptable range.

The aims of this study were to compare the chondroitin sulphate (CS) levels in gingival crevicular fluid (GCF) of moved canines using either 70 or 120 g of orthodontic force, and to compare the rate of tooth movement and the amount of pain between these two force magnitudes. Sixteen patients (6 males and 10 females; aged 16.91 ± 2.99 years), with class I malocclusion, who required orthodontic treatment with first premolar extractions, were recruited. The force magnitudes used to move the maxillary canines distally were controlled at 70 and 120 g on the right and the left sides, respectively. GCF samples were collected with Periopaper(®) strips before and during orthodontic tooth movement. Competitive ELISA with monoclonal antibody was used to measure the CS levels. The distance of tooth movement and the amount of pain assessed by visual analog scale (VAS) scores were evaluated. The medians of CS levels during the loaded period were significantly greater than those during the unloaded period (P < 0.05). The differences between the medians of CS levels of 70 g and 120 g retraction force during each 1 week period were not significant. There was no significant difference in the rates of canine movement between these two force magnitudes. However, using 120 g, the medians of VAS scores were significantly greater than those with 70 g (P < 0.05). Collectively, 70 g retraction force appears to be sufficient and more suitable than 120 g force as it causes no difference in biochemically-assessed bone remodelling activity, the same rate of tooth movement, reduced pain and better comfort.

No abstract