Late Cretaceous records of environmental change suggest that Deccan Traps (DT) volcanism contributed to the Cretaceous-Paleogene boundary (KPB) ecosystem crisis. However, testing this hypothesis requires identification of the KPB in the DT. We constrain the location of the KPB with high-precision argon-40/argon-39 data to be coincident with changes in the magmatic plumbing system. We also found that the DT did not erupt in three discrete large pulses and that >90% of DT volume erupted in <1 million years, with ~75% emplaced post-KPB. Late Cretaceous records of climate change coincide temporally with the eruption of the smallest DT phases, suggesting that either the release of climate-modifying gases is not directly related to eruptive volume or DT volcanism was not the source of Late Cretaceous climate change.

Bolide impact and flood volcanism compete as leading candidates for the cause of terminal-Cretaceous mass extinctions. High-precision (40)Ar/(39)Ar data indicate that these two mechanisms may be genetically related, and neither can be considered in isolation. The existing Deccan Traps magmatic system underwent a state shift approximately coincident with the Chicxulub impact and the terminal-Cretaceous mass extinctions, after which ~70% of the Traps' total volume was extruded in more massive and more episodic eruptions. Initiation of this new regime occurred within ~50,000 years of the impact, which is consistent with transient effects of impact-induced seismic energy. Postextinction recovery of marine ecosystems was probably suppressed until after the accelerated volcanism waned.

No abstract

Layered growth of molybdenum disulphide (MoS2) was successfully achieved by pulsed laser deposition (PLD) method on c ‐plane sapphire substrate. Growth of monolayer to a few monolayer MoS2, dependent on the pulsed number of excimer laser in PLD is demonstrated, indicating the promising controllability of layer growth. Among the samples with various pulse number deposition, the frequency difference (A1g–E12g) in Raman analysis of the 70 pulse sample is estimated as 20.11 cm–1, suggesting a monolayer MoS2 was obtained. Two‐dimensional (2D) layer growth of MoS2 is confirmed by the streaky reflection high energy electron diffraction (RHEED) patterns during growth and the cross‐sectional view of transmission electron microscopy (TEM). The in‐plane relationship, (0006) sapphire//(0002)MoS2and [21̄1̄0] sapphire//[01̄1̄0]MoS2 is determined. The results imply that PLD is suitable for layered MoS2 growth. Additionally, the oxide states of Mo 3d core level spectra of PLD grown MoS2, analysed by X‐ray photoelectron spectroscopy (XPS), can be effectively reduced by adopting a post sulfurization process. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)

No abstract

No abstract

No abstract

No abstract