No abstract

We developed a polymeric 2-DE chip system. The chip consisted of an IEF region, an SDS-PAGE region, a valveless connection port, and a sample introduction port. A "junction structure" as a valveless connection port, which allowed separating and connecting the first- and second-dimensional gels, was fabricated between their regions. A "solution inlet" as a sample introduction port was fabricated to perform the liquid and sample introductions without solution leakage. Simultaneous sample monitoring was performed using the on-chip detection system. The performances of the system were demonstrated using commercially available proteins as a standard specimen and tissue-extracted proteins as the real samples. All procedures were employed without any movement of relocation part. This new 2-D separation system realized improved labor-intensive operations and a reduced experimental time.

A new form of microchip isoelectric focusing that allows efficient coupling with pretreatment processes is reported. The sample is conveyed in a carrier ampholyte solution to the separation channel that is connected at both ends by two V-shaped lead channels, which supply electrode solutions to the connection point and complete the electrical connection to off-chip electrodes. The relatively high electric conductivity of the electrode solutions compared with that of the pH gradient enables focusing with a 2% loss of applied voltage at the electrodes using the lead channels. A glass microchip was constructed specifically for this configuration. The channel wall was coated with polydimethylacrylamide, and the IEF chip was operated in a chip holder equipped with on-chip connector valves. A plug of fluorescence-labeled peptide p I markers with p I values ranging from 3.64 to 9.56 with carrier ampholyte solution (pH 3-10) was introduced into the separation channel. When the plug reached the channel segment (24 mm in length) between the connection points with the electrolyte lead channels, isoelectric focusing was started after filling the lead channels with electrolyte solutions. The peptide markers were observed using scanning fluorescence detection. The entire range of the pH gradient was established in the segment after approximately 2 min. Isoelectric focusing of three consecutively injected sample plugs containing different p I markers was demonstrated.

We developed a fully automated electrophoresis system for rapid and highly reproducible protein analysis. All the two-dimensional (2D) electrophoresis procedures including isoelectric focusing (IEF), on-part protein staining, sodium dodecyl sulfate polyacrylamide gel electrophoresis (SDS-PAGE), and in situ protein detection were automatically completed. The system comprised Peltiert devices, high-voltage generating devices, electrodes, and three disposable polymethylmethacrylate (PMMA) parts for IEF, reaction chambers, and SDS-PAGE. Because of miniaturization of the IEF part, rapid IEF was achieved in 30 min. A gel with a tapered edge gel on the SDS-PAGE part realized a connection between the parts without use of a gluing material. A biaxial conveyer was employed for the part relocation, sample introduction, and washing processes to realize a low-maintenance and cost-effective automation system. Performances of the system and a commercial minigel system were compared in terms of detected number, resolution, and reproducibility of the protein spots. The system achieved high-resolution comparable to the minigel system despite shorter focusing time and smaller part dimensions. The resulting reproducibility was better or comparable to the performance of the minigel system. Complete 2D separation was achieved within 1.5 h. The system is practical, portable, and has automation capabilities.