Abstract.We present a crust and mantle velocity structure for the West Iberia passive continental margin derived from a 320-kin-long wide-angle seismic profile acquired in the southern Iberia Abyssal Plain. We observe a 170-kin-wide oceancontinent transition zone which includes a pair of overlapping peridotire ridges and is bounded by

[1] We conducted a seismic refraction experiment across Flemish Cap and into the deep basin east of Newfoundland, Canada, and developed a velocity model for the crust and mantle from forward and inverse modeling of data from 25 ocean bottom seismometers and dense air gun shots. The continental crust at Flemish Cap is 30 km thick and is divided into three layers with P wave velocities of 6.0-6.7 km/s. Across the southeast Flemish Cap margin, the continental crust thins over a 90-km-wide zone to only 1.2 km. The ocean-continent boundary is near the base of Flemish Cap and is marked by a fault between thinned continental crust and 3-km-thick crust with velocities of 4.7-7.0 km/s interpreted as crust from magma-starved oceanic accretion. This thin crust continues seaward for 55 km and thins locally to $1.5 km. Below a sediment cover (1.9-3.1 km/s), oceanic layer 2 (4.7-4.9 km/s) is $1.5 km thick, while layer 3 (6.9 km/s) seems to disappear in the thinnest segment of the oceanic crust. At the seawardmost end of the line the crust thickens to $6 km. Mantle with velocities of 7.6-8.0 km/s underlies both the thin continental and thin oceanic crust in an 80-km-wide zone. A gradual downward increase to normal mantle velocities is interpreted to reflect decreasing degree of serpentinization with depth. Normal mantle velocities of 8.0 km/s are observed $6 km below basement. There are major differences compared to the conjugate Galicia Bank margin, which has a wide zone of extended continental crust, more faulting, and prominent detachment faults. Crust formed by seafloor spreading appears symmetric, however, with 30-km-wide zones of oceanic crust accreted on both margins beginning about 4.5 m.y. before formation of magnetic anomaly M0 ($118 Ma).

Abstract. We present a wide-angle seismic refraction study of an 80x40 km region of the southern Iberia Abyssal Plain, south of Galicia Bank. An intersecting grid of two E-W and four N-S wide-angle reflection/refraction profiles is used to define variations of the basement velocity blocks immediately south of Galicia Bank. This crust is underlain by a high-velocity layer (7.3-7.9 km/s) of weakly serpentinized (i.e., 0-25%) peridotite, which exists throughout the eastern part of the survey area. Basement within the OCT appears to consist dominantly of a broad region of exposed upper mantle that has been serpentinized heterogeneously both vertically and horizontally. In the southeast sector of our survey where basement topography deepens and becomes subdued, continental fault blocks are absent; instead, basement contains an upper layer of more pervasively serpentinized (i.e., 25-45%) peridotite that is ~2 km thick. This layer is characterized by low velocity at the top of basement (4.2 km/s) that increases rapidly with depth, and it probably corresponds to a seismically unreflective layer, previously identified in reflection profiles to the south of our survey. In the western section of our survey, beneath a series of elevated basement ridges, velocities are reduced within both the upper •asement layer (3.5-6.0 km/s) and lower layer (6.4-7.5 km/s). These changes suggest that both upper and lower layers have become more highly serpentinized (with values of 60-100% in the upper layer and 25-45% in the lower layer) probably during the last stages of rifting and immediately before formation of oceanic crust. A normal or slow spreading oceanic crustal structure is not found within the survey region. Thus it appears that the onset of seafloor spreading occurs in the region west of the peridotite ridge sampled at ODP Site 897 and east of the J magnetic anomaly.

We present a compressional seismic velocity profile of the crust of the eastern margin of the Grand Banks of Newfoundland, Canada. This velocity model was obtained by a tomographic inversion of wide‐angle data recorded on a linear array of 24 ocean bottom seismometers (OBSs). At the landward side, we imaged a crustal thickness of 27 km in Flemish Pass and beneath Beothuk Knoll, which is thinner than the 35‐km‐thick crust of the central Grand Banks. We therefore assume that the eastern rim of the Grand Banks stretched uniformly by 25%. Farther seaward, the continental crust tapers rapidly beneath the continental slope to ∼6 km thickness. In the distal margin we find a 60‐km‐wide zone with seismic velocities between 5.0 and 6.5 km s−1 that thins to the southeast from 6 to 2 km, which we interpret as highly extended continental crust. Contrary to other seismic studies of the margins of the Grand Banks, we find seismic velocities of 8 km s−1 and higher beneath this thin crustal layer in the continent‐ocean transition. We conclude that mantle was locally emplaced at shallow levels without significant hydration from seawater or serpentinized mantle was removed along a décollement in the final stages of continental rifting. The outer edge of highly extended continental crust borders a 25‐km‐wide zone where seismic velocities increase gradually from 6.3 km s−1 just below the top of acoustic basement to 7.7 km s−1 at 5 km below basement. We interpret this area as a relatively narrow zone of exhumed and serpentinized continental mantle. Seaward, we imaged a thin and laterally heterogeneous layer with a seismic velocity that increases sharply from 5.0 km s−1 in basement ridges to 7.0 km s−1 at its base, overlying mantle velocities between 7.8 and 8.2 km s−1. We interpret this area as unroofed mantle and very thin oceanic crust that formed at an incipient, magma‐starved, ultraslow spreading ridge. A comparison of the conjugate rifted margins of the eastern Grand Banks and the Iberia Abyssal Plain show that they exhibit a similar seaward progression from continental crust to mantle to oceanic crust. This indicates that before continental breakup, rifting exhumed progressively deeper sections of the continental lithosphere on both conjugate margins. A comparison between the continent‐ocean transition of the Grand Banks and Flemish Cap shows that the final phase of continental rifting and the formation of the first oceanic crust required more time at the Grand Banks margin than at the southeastern margin of Flemish Cap.

Prestack depth-migrated seismic reflection data collected off Flemish Cap on the Newfoundland margin show a structure of abruptly thinning continental crust that leads into an oceanic accretion system. Within continental crust, there is no clear evidence for detachment surfaces analogous to the S reflection off the conjugate Galicia Bank margin, demonstrating a first-order asymmetry in final rift development. Anomalously thin (3-4 km), magmatically produced oceanic crust abuts very thin continental crust and is highly tectonized. This indicates that initial accretion of the oceanic crust was in a magma-limited setting similar to presentday ultraslow spreading environments. Seaward, oceanic crust thins to Ͻ1.3 km and exhibits an unusual, highly reflective layering. We propose that a period of magma starvation led to exhumation of mantle in an oceanic core complex that was subsequently buried by deep-marine sheet flows to form this layering. Subsequent seafloor spreading formed normal, ϳ6-km-thick oceanic crust. This interpretation implies large fluctuations in the available melt supply during the early stages of seafloor spreading before a more typical slow-spreading system was established.

S U M M A R YA P-wave velocity model along a 565-km-long profile across the Grand Banks-Newfoundland Basin rifted margin is presented. Continental crust ∼36 km thick beneath the Grand Banks is divided into upper (5.8-6.25 km s −1 ), middle (6.3-6.53 km s −1 ) and lower crust (6.77-6.9 km s −1 ), consistent with velocity structure of Avalon zone Appalachian crust. Syn-rift sediment sequences 6-7 km thick occur in two primary layers within the Jeanne d'Arc and the Carson basins (∼3 km s −1 in upper layer; ∼5 km s −1 in lower layer). Abrupt crustal thinning (Moho dip ∼35 • ) beneath the Carson basin and more gradual thinning seaward forms a 170-km-wide zone of rifted continental crust. Within this zone, lower and middle continental crust thin preferentially seawards until they are completely removed, while very thin (<3 km) upper crust continues ∼60 km farther seawards. Adjacent to the continental crust, high-velocity gradients (0.5-1.5 s −1 ) define an 80-km-wide zone of transitional basement that can be interpreted as exhumed, serpentinized mantle or anomalously thin oceanic crust, based on its velocity model alone. We prefer the exhumed-mantle interpretation after considering the non-reflective character of the basement and the low amplitude of associated magnetic anomalies, which are atypical of oceanic crust. Beneath both the transitional basement and thin (<6 km) continental crust, a 200-km-wide zone with reduced mantle velocities (7.6-7.9 km s −1 ) is observed, which is interpreted as partially (<10 per cent) serpentinized mantle. Seawards of the transitional basement, 2-to 6-km-thick crust with layer 2 (4.5-6.3 km s −1 ) and layer 3 (6.3-7.2 km s −1 ) velocities is interpreted as oceanic crust. Comparison of our crustal model with profile IAM-9 across the Iberia Abyssal Plain on the conjugate Iberia margin suggests asymmetrical continental breakup in which a wider zone of extended continental crust has been left on the Newfoundland side.

[1] The Nova Scotia continental margin off eastern Canada marks a transition from a volcanic to a nonvolcanic style of rifting. The northern (nonvolcanic) segment of the margin was studied by a 490-km-long refraction seismic line with dense air gun shots, coincident with previous deep reflection profiles. A P wave velocity model was developed from forward and inverse modeling of the wide-angle data from 19 ocean bottom seismometers and coincident normal incidence reflection profiles. The continental crust has a maximum thickness of 36 km and is divided into three layers with velocities of 5.7-6.9 km/s. Crustal thinning down to 3 km occurs in a 180-km-wide zone and the sediment cover in this area is up to 15 km thick. Farther seaward, a 150-km-wide transition zone is observed with a 5-km-thick lower layer (7.2-7.6 km/s) interpreted as partially serpentinized mantle. At the landward end, this layer is overlain by highly altered continental crust (5.4 km/s) extending up to the seaward limit of the Jurassic salt province. Farther seaward, the upper layer is interpreted as exhumed and highly serpentinized mantle (5.1 km/s) separated from the lower layer by subhorizontal reflectivity, which probably represents a serpentinization front. Oceanic crustal thickness is 4 km with layer 2 velocities of 4.6-5.0 km/s. Layer 3 velocities of 6.4-6.55 km/s are lower than typical lower oceanic crust velocities but consistent with a low magma supply and increased tectonism as observed on the reflection profile. This reduced magma production might be related to the proximity of the Newfoundland transform margin.

The Davis Strait transform margin was studied using a 630‐km‐long wide‐angle reflection/refraction seismic transect extending from SE Baffin Island to Greenland. Dense airgun shots were recorded by 28 ocean bottom seismometers deployed along the line. A P wave velocity model was developed from forward and inverse modeling of the wide‐angle data and incorporation of coincident deep multichannel reflection seismic data. Off Baffin Island in the Saglek Basin, 7 to 11‐km‐thick two‐layered continental crust (5.8–6.6 km/s) is observed. Off Greenland, continental crust is divided into three layers (5.4–6.8 km/s) with a maximum thickness of 20 km. Farther offshore Greenland the crust thins to 7–12 km and the lower crust disappears. Between the continental blocks a 140‐km‐wide zone with oceanic crust (layer 2 is 5.4–6.2 km/s and layer 3 is 6.7–7.0 km/s) is located. The western half of this zone is interpreted to be part of a volcanic margin with seaward dipping reflectors; the eastern part is associated with the Ungava fault zone (UFZ), the major transform fault in Davis Strait. The UFZ thus acted as leaky transform fault during phases of transtension. Southward flow of material from the Iceland plume created a 4 to 8‐km‐thick underplated layer (7.4 km/s) beneath the thinned portions of the continental crust and beneath previously emplaced oceanic crust. Plume related Paleogene volcanism is indicated by an up to 4‐km thick layer (4.3–5.8 km/s) with basalts and interbedded sediments that can be traced from SE Baffin Island 400 km toward the east.