[1] The evolution of the Atlantic Meridional Overturning Circulation (MOC) in 30 models of varying complexity is examined under four distinct Representative Concentration Pathways. The models include 25 Atmosphere-Ocean General Circulation Models (AOGCMs) or Earth System Models (ESMs) that submitted simulations in support of the 5th phase of the Coupled Model Intercomparison Project (CMIP5) and 5 Earth System Models of Intermediate Complexity (EMICs). While none of the models incorporated the additional effects of ice sheet melting, they all projected very similar behaviour during the 21st century. Over this period the strength of MOC reduced by a best estimate of 22% (18%-25%; 5%-95% confidence limits) for RCP2.6, 26% (23%-30%) for RCP4.5, 29% (23%-35%) for RCP6.0 and 40% (36%-44%) for RCP8.5. Two of the models eventually realized a slow shutdown of the MOC under RCP8.5, although no model exhibited an abrupt change of the MOC. Through analysis of the freshwater flux across 30 -32 S into the Atlantic, it was found that 40% of the CMIP5 models were in a bistable regime of the MOC for the duration of their RCP integrations. The results support previous assessments that it is very unlikely that the MOC will undergo an abrupt change to an off state as a consequence of global warming.
oro.open.ac.uk Journal of Climate EARLY ONLINE RELEASEThis is a preliminary PDF of the author-produced manuscript that has been peer-reviewed and accepted for publication. Since it is being posted so soon after acceptance, it has not yet been copyedited, formatted, or processed by AMS Publications. This preliminary version of the manuscript may be downloaded, distributed, and cited, but please be aware that there will be visual differences and possibly some content differences between this version and the final published version.
Both historical and idealized climate model experiments are performed with a variety of Earth system models of intermediate complexity (EMICs) as part of a community contribution to the Intergovernmental Panel on Climate Change Fifth Assessment Report. Historical simulations start at 850 CE and continue through to 2005. The standard simulations include changes in forcing from solar luminosity, Earth's orbital configuration, CO2, additional greenhouse gases, land use, and sulphate and volcanic aerosols. In spite of very different modelled pre-industrial global surface air temperatures, overall 20th century trends in surface air temperature and carbon uptake are reasonably well simulated when compared to observed trends. Land carbon fluxes show much more variation between models than ocean carbon fluxes, and recent land fluxes appear to be slightly underestimated. It is possible that recent modelled climate trends or climate–carbon feedbacks are overestimated resulting in too much land carbon loss or that carbon uptake due to CO2 and/or nitrogen fertilization is underestimated. Several one thousand year long, idealized, 2 × and 4 × CO2 experiments are used to quantify standard model characteristics, including transient and equilibrium climate sensitivities, and climate–carbon feedbacks. The values from EMICs generally fall within the range given by general circulation models. Seven additional historical simulations, each including a single specified forcing, are used to assess the contributions of different climate forcings to the overall climate and carbon cycle response. The response of surface air temperature is the linear sum of the individual forcings, while the carbon cycle response shows a non-linear interaction between land-use change and CO2 forcings for some models. Finally, the preindustrial portions of the last millennium simulations are used to assess historical model carbon-climate feedbacks. Given the specified forcing, there is a tendency for the EMICs to underestimate the drop in surface air temperature and CO2 between the Medieval Climate Anomaly and the Little Ice Age estimated from palaeoclimate reconstructions. This in turn could be a result of unforced variability within the climate system, uncertainty in the reconstructions of temperature and CO2, errors in the reconstructions of forcing used to drive the models, or the incomplete representation of certain processes within the models. Given the forcing datasets used in this study, the models calculate significant land-use emissions over the pre-industrial period. This implies that land-use emissions might need to be taken into account, when making estimates of climate–carbon feedbacks from palaeoclimate reconstructions
Abstract. We analyze the source code of eight coupled climate models, selected from those that participated in the CMIP5 (Taylor et al., 2012) or EMICAR5 Zickfeld et al., 2013) intercomparison projects. For each model, we sort the preprocessed code into components and subcomponents based on dependency structure. We then create software architecture diagrams that show the relative sizes of these components/subcomponents and the flow of data between them. The diagrams also illustrate several major classes of climate model design; the distribution of complexity between components, which depends on historical development paths as well as the conscious goals of each institution; and the sharing of components between different modeling groups. These diagrams offer insights into the similarities and differences in structure between climate models, and have the potential to be useful tools for communication between scientists, scientific institutions, and the public.
The Paleocene-Eocene Thermal Maximum (PETM), ∼55.53 million years before present, was an abrupt warming event that involved profound changes in the carbon cycle and led to major perturbations of marine and terrestrial ecosystems. The PETM was triggered by the release of a massive amount of carbon, and thus, the event provides an analog for future climate and environmental changes given the current anthropogenic CO 2 emissions. Previous attempts to constrain the amount of carbon released have produced widely diverging results, between 2000 and 10,000 gigatons carbon (GtC). Here we use the UVic Earth System Climate Model in conjunction with a recently published compilation of PETM temperatures to constrain the initial atmospheric CO 2 concentration as well as the total mass of carbon released during the event. Thirty-six simulations were initialized with varying ocean alkalinity, river runoff, and ocean sediment cover. Simulating various combinations of pre-PETM CO 2 levels (840, 1680, and 2520 ppm) and total carbon releases (3000, 4500, 7000, and 10,000 GtC), we find that both the 840 ppm plus 7000 GtC and 1680 ppm plus 7000-10,000 GtC scenarios agree best with temperature reconstructions. Bottom waters outside the Arctic and North Atlantic Oceans remain well oxygenated in all of our simulations. While the recovery time and rates are highly dependent on ocean alkalinity and sediment cover, the maximum temperature anomaly, used here to constrain the amount of carbon released, is less dependent on this slow-acting feedback.
The Palaeocene-Eocene Thermal Maximum, approximately 55 million years ago, was a period of rapid warming linked to a massive release of carbon to the ocean-atmosphere system 1 . This warming event was also marked by widespread dissolution of carbonates at the sea floor 2 . The acidification of deep waters was generally more extensive and severe in the Atlantic and Caribbean, with more modest changes in the Southern and Pacific oceans 3-5 . Here we use the UVic ESCM global climate model to show that corrosive deep water spreading from the North Atlantic can explain the spatial variations in carbonate dissolution during the Palaeocene-Eocene Thermal Maximum. In our simulations, highly corrosive waters accumulate in the deep North Atlantic at the onset of the event. Several thousand years after an imposed atmospheric carbon release, warming of the deep ocean destabilizes the North Atlantic water column and triggers deep-water formation. This deep convection causes the corrosive bottom water to spill over an equatorial sill into the South Atlantic. The bottom water then spreads through the Southern and Pacific oceans, progressively gaining alkalinity. We conclude that the pattern of sediment dissolution simulated along the path taken by the corrosive water is consistent with most dissolution estimates from the sediment record.The Palaeocene-Eocene Thermal Maximum (PETM) is a warming event of significant interest because of its relevance to present-day climate change. This palaeoclimate event illustrates how a large and rapid release of carbon can impact physical, chemical and biological systems worldwide 6-8 . Numerous studies have estimated the rate and magnitude of the carbon release to compare the PETM with modern climate change, including approaches based on climate sensitivity 9,10 , seafloor CaCO 3 dissolution 2,3,11 , and C-isotope records 3,12 . Methods based on the intensity of dissolution, such as changes in the position of the lysocline and the calcite compensation depth, are particularly useful as these variables relate directly to the amount of carbon entering the ocean without assuming an isotopic ratio. However, seafloor dissolution was not globally uniform during the PETM (ref. 3), complicating estimates of the accompanying global rise in atmospheric CO 2 .
We integrate published stable isotopic, chemical, mineralogical, and biotic data from the onset of the Paleocene-Eocene thermal maximum (PETM) at Site 690, Maud Rise in the Southern Ocean. The integrated data set documents a sequence of environmental steps including warming of the ocean from the surface downward, and modification of its thermal and nutrient structure, acidification of the deep ocean, and the onset of continental weathering. The age of the events with respect to the onset of the PETM is calibrated with three different age models. The relative and absolute timing of the steps are compared with simulated temperature, salinity, calcite saturation, and dissolved PO 4 and O 2 , at different depths in the ocean, generated with the UVic Earth System Climate Model of intermediate complexity. The simulation supports the top to bottom transfer of heat and carbon, and generally agrees with age models in terms of the durations of leads and lags in temperature, C-isotope, and biotic responses. Moreover, the simulation shows that stratification increased and the nutricline strengthened at the onset of the PETM. These environmental changes explain the abundance of deep-dwelling nannoplankton and foraminifera during the early part of the event. The modeled calcite saturation is consistent with a harsh deep-sea habitat at the time of the benthic foraminiferal extinction.
Both historical and idealized climate model experiments are performed with a variety of Earth System Models of Intermediate Complexity (EMICs) as part of a community contribution to the Intergovernmental Panel on Climate Change Fifth Assessment Report. Historical simulations start at 850 CE and continue through to 2005. The standard simulations include changes in forcing from solar luminosity, Earth's orbital configuration, CO<sub>2</sub>, additional greenhouse gases, land-use, and sulphate and volcanic aerosols. In spite of very different modelled pre-industrial global surface air temperatures, overall 20th century trends in surface air temperature and carbon uptake are reasonably well simulated when compared to observed trends. Land carbon fluxes show much more variation between models than ocean carbon fluxes, and recent land fluxes seem to be underestimated. It is possible that recent modelled climate trends or climate-carbon feedbacks are overestimated resulting in too much land carbon loss or that carbon uptake due to CO<sub>2</sub> and/or nitrogen fertilization is underestimated. <br><br> Several one thousand year long, idealized, 2x and 4x CO<sub>2</sub> experiments are used to quantify standard model characteristics, including transient and equilibrium climate sensitivities, and climate-carbon feedbacks. The values from EMICs generally fall within the range given by General Circulation Models. Seven additional historical simulations, each including a single specified forcing, are used to assess the contributions of different climate forcings to the overall climate and carbon cycle response. The response of surface air temperature is the linear sum of the individual forcings, while the carbon cycle response shows considerable synergy between land-use change and CO<sub>2</sub> forcings for some models. Finally, the preindustrial portions of the last millennium simulations are used to assess historical model carbon-climate feedbacks. Given the specified forcing, there is a tendency for the EMICs to underestimate the drop in surface air temperature and CO<sub>2</sub> between the Medieval Climate Anomaly and the Little Ice Age estimated from paleoclimate reconstructions. This in turn could be a result of errors in the reconstructions of volcanic and/or solar radiative forcing used to drive the models or the incomplete representation of certain processes or variability within the models. Given the datasets used in this study, the models calculate significant land-use emissions over the pre-industrial. This implies that land-use emissions might need to be taken into account, when making estimates of climate-carbon feedbacks from paleoclimate reconstructions
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.