A series of ternary phosphate glasses in the form of (PbO)x(ZnO)60-x(P2O5)40 where x = 0-60 mol%, have been successfully prepared by conventional melt-quenching technique. The physical and elastic properties of the glasses have been investigated using pulse echo technique. The longitudinal and shear velocity of the glasses were measured using the MBS8000 ultrasonic data acquisition system at 10 MHz frequency in room temperature. The density, ultrasonic velocity and elastic moduli are found to be composition dependent and the correlation between the elastic moduli with the atomic packing density is discussed in detailed. The shielding parameters, mass attenuation coefficients, half value layers and exposure buildup factor (EBF) values have been computed using WinXCom program with the use of GP fitting method, and variation of shielding parameters are discussed for the effect of PbO addition into the glasses and photon energy. An increase in the density of the glasses results in a change in crosslink density. The sound velocity and elastic properties increased with PbO content and increase in Poisson's ratio trend suggests that the rigidity of the glasses has decreased. Besides, the replacement of ZnO by PbO causes an increase in mass attenuation coefficient, while the half value layer and the exposure buildup factor were decreased and these glasses has been potentially used as shielding material.

No abstract

No abstract

This paper presents a study of physical and structural properties of Hydroxyapatite (HA) reinforced with different compositions of 45S5 (SG) bioglasses at different sintering temperatures. Hydroxyapatite reinforced with different compositions of 45S5 bioglasses had been prepared and investigated in terms of density, mechanical strength, and crystalline phases. A decrease in the density of HA was observed after the incorporation of SG, owing to the trapping of air in the SG reinforced HA after sintering process. When compared to the pure HA, different crystalline phases, such as -tricalcium phosphate, calcium phosphate silicate and sodium calcium phosphate, were detected when different compositions of SG were incorporated into the HA

This study aimed to perform an extensive characterization of a 74.75TeO2–0.25V2O5–(25 − x)B2O3-xNd2O3 glass system with (x = 0, 0.5, 1.0, and 1.5 mol%) for radiation shielding properties. Linear and mass attenuation coefficients were determined using Phy-X PSD software and compared with the simulation using Monte Carlo software MCNPX (version 2.7.0). Half value layer, mean free path, tenth value layer, effective atomic number, exposure buildup factor, and energy absorption buildup factors of VTBNd0.0, VTBNd0.5, VTBNd1.0, and VTBNd1.5 glasses were determined, respectively. The results showed that boron (III) oxide and neodymium (III) oxide substitution has an obvious impact on the gamma ray attenuation properties of the studied glasses. It can be concluded that the VTBNd1.5 sample with the highest content of neodymium (III) oxide (1.5 mol%) is the superior sample for shielding of gamma radiation in the investigated energy range.