No abstract

No abstract

Organic contamination of water bodies in which benthic microbial fuel cells (benthic MFCs) are installed, and organic crossover from the anode to the cathode of membraneless MFCs, is a factor causing oxygen depletion and substrate loss in the cathode due to the growth of heterotrophic aerobic bacteria. This study examines the possible use of silver nanoparticles (AgNPs) as a cathodic catalyst for MFCs suffering from organic contamination and oxygen depletion. Four treated cathodes (AgNPs-coated, Pt/C-coated, Pt/C+AgNPs-coated, and plain graphite cathodes) were prepared and tested under high levels of organics loading. During operation (fed with 50 mM acetate), the AgNPs-coated system showed the highest DO concentration (0.8 mg/L) in the cathode area as well as the highest current (ranging from 0.04 to 0.12 mA). Based on these results, we concluded that (1) the growth of oxygen-consuming heterotrophic microbes could be inhibited by AgNPs, (2) the function of AgNPs as a bacterial growth inhibitor resulted in a greater increase of DO concentration in the cathode than the other tested cathode systems, (3) AgNPs could be applied as a cathode catalyst for oxygen reduction, and as a result (4) the MFC with the AgNPs-coated cathode led to the highest current generation among the tested MFCs.

No abstract

No abstract

To scale-up microbial fuel cells (MFCs), installing multiple unit cells in a common reactor has been proposed; however, there has been a serious potential drop when connecting unit cells in series. To determine the source of the loss, a basic stack-MFC (BS-MFC) has been devised, and the results show that the phenomenon is due to ions on the anode electrode traveling through the electrolyte to be reduced at the cathode connected in series. As calculated by means of the percentage potential drop, the degree of potential drop decreased with an increase in the unit-cell distance. When the distance was increased from 1 to 8 cm, the percentage potential drop in BS-MFC1 decreased from 46.76 ± 0.90 to 45.08 ± 0.70 % and in BS-MFC2 from 46.41 ± 0.95 to 43.82 ± 2.23 %. As the p-value of the t-test was lower than 0.05, the difference was considered significant; however, if the unit cells are installed far enough from each other to avoid the potential drop phenomenon, the system will be less dense, consequently reducing the ratio of electrode area per volume of anode compartment and decreasing the power density of the system. Finally, this study suggests design criteria for scaling-up MFC systems: Multiple-electrode-installed MFCs are modularized, and the unit cells are connected in series across the module (connecting each unit cell does not share the anolyte).

No abstract

No abstract