Overdense plasmas are usually opaque to laser light. However, when the light is of sufficient intensity to drive electrons in the plasma to near light speeds, the plasma becomes transparent. This process-known as relativistic transparency-takes just a tenth of a picosecond. Yet all studies of relativistic transparency so far have been restricted to measurements collected over timescales much longer than this, limiting our understanding of the dynamics of this process. Here we present time-resolved electric field measurements (with a temporal resolution of ∼50 fs) of the light, initially reflected from, and subsequently transmitted through, an expanding overdense plasma. Our result provides insight into the dynamics of the transparent-overdense regime of relativistic plasmas, which should be useful in the development of laser-driven particle accelerators, X-ray sources and techniques for controlling the shape and contrast of intense laser pulses.

No abstract

The enhancement of stimulated Raman backscattering (SRBS) amplification was demonstrated by introducing a plasma density gradient along the pump and the seed interaction path and by a novel double-pass design. The energy transfer efficiency was significantly improved to a level of 6.4%. The seed pulse was amplified by a factor of more than 20 000 from the input in a 2mm long plasma, which also exceeded the intensity of the pump pulse by 2 orders of magnitude. This was accompanied by very effective pulse compression, from 500fsto90fs in the first pass measurements and in the second pass down to approximately 50fs, as it is indicated by the energy-pulse duration relation. Further improvements to the energy transfer efficiency and the SRBS performance by extending the region of resonance is also discussed where a uniform ∼4mm long plasma channel for SRBS was generated by using two subsequent laser pulses in an ethane gas jet.

A new small angle slot (SAS) divertor concept has been developed to enhance neutral cooling across the divertor target by coupling a closed slot structure with appropriate target shaping. Initial tests on DIII-D find a strong interplay between such anticipated ‘SAS’ effects and cross-field drifts, favouring operation with the ion B  ×  ∇B drift away from the X-point, as currently employed for advanced tokamaks. This offers the following key improvements relative to DIII-D’s open lower divertor or partially-closed upper divertor: (i) SAS allows for transition to low temperature moderately detached divertor conditions with Te  ≲  10 eV at very low main plasma densities, lower than are usually attainable at all in DIII-D high confinement (H-mode) plasmas as used in these tests; (ii) Pedestal performance and core confinement are significantly improved with SAS. The final confinement collapse associated with the onset of X-point MARFE (multifaceted asymmetric radiation from the edge) following deep detachment occurs at significantly higher pedestal densities, thus widening the window of H-mode operation compatible with a dissipative divertor. For operation with the ion B  ×  ∇B drift toward the X-point, the divertor plasma transitions to a bifurcative detached state at much higher densities, similar to other divertor configurations in DIII-D. These results highlight the strong interplay between divertor closure and drifts, and point to an interesting divertor optimization path to explore that offers potential for future fusion reactors.

Impurity seeding studies in the small angle slot (SAS) divertor at DIII-D have revealed a strong relationship between the detachment onset and pedestal characteristics with both target geometry and impurity species. N2 seeding in the slot has led to the first simultaneous observation of detachment on the entire suite of boundary diagnostics viewing the SAS without degradation of core confinement. SOLPS-ITER simulations with D+C+N, full cross field drifts, and n–n collisions activated are performed for the first time in DIII-D to interpret the behavior. This highlights a strong effect of divertor configuration and plasma drifts on the recycling source distribution with significant consequences on plasma flows. Flow reversal is found for both main ions and impurities affecting strongly the impurity transport and providing an explanation for the observed dependence on the strike point location of the detachment onset and impurity leakage found in the experiments. Matched discharges with either nitrogen or neon injection show that while nitrogen does not significantly affect the pedestal, neon leads to increased pedestal pressure gradients and improved pedestal stability. Little nitrogen penetrates in the core, but a significant amount of neon is found in the pedestal consistent with the different ionization potentials of the two impurities. This work demonstrates that neutral and impurity distributions in the divertor can be controlled through variations in strike point locations in a fixed baffle structure. Divertor geometry combined with impurity seeding enables mitigated divertor heat flux balancing core contamination, thus leading to enhanced divertor dissipation and improved core-edge compatibility, which are essential for ITER and for future fusion reactors.

A plasma-based resonant backward Raman amplifier/compressor for high power amplification of short laser pulses might, under ideal conditions, convert as much as 90% of the pump energy to the seed pulse. While the theoretical highest possible efficiency of this scheme has not yet been achieved, larger efficiencies than ever before obtained experimentally (6.4%) are now being reported, and these efficiencies are accompanied by strong pulse compression. Based on these recent extensive experiments, it is now possible to deduce that the experimentally realized efficiency of the amplifier is likely constrained by two factors, namely the pump chirp and the plasma wavebreaking, and that these experimental observations may likely involve favorable compensation between the chirp of the laser and the density variation of the mediating plasma. Several methods for further improvement of the amplifier efficiency in current experiments are suggested.

We describe laser ablation of Si under water by 5 ns, 355 nm and 100 fs, 800 nm pulses. Compared to that in air, an approximately twofold improvement in the ablation rate is found in water for femtosecond and nanosecond pulses. For higher laser irradiances, the plasma that forms at the water-air interface hampers further improvement of the ablation rate. We investigated the enhanced ablation process in water and found that the cavity-confinement geometry that increases the laser energy coupling to the target and allows more energy to be transferred to the cavity sidewalls plays an important role in the escalated material removal process. In addition, we show that the water layer that effectively reduces the oxidation and redeposition of the ablated debris is also responsible for improvements in the ablation process.

We report observations from the DIII-D tokamak indicating that boron (B) powder injection in tokamak plasmas improves wall conditions similarly to glow discharge boronization (GDB). Isotopically enriched B powder (B11 > 95%) was introduced gravitationally in a sequence of H-mode plasma discharges at rates up to ∼160 mg s−1 for durations up to 3 s. Boron injection to cumulative amounts ≤0.1 g appeared to improve wall conditions similarly to boronization, with indications of reduced wall fueling, reduced recycling at the outer strike point and reduced impurity content at breakdown. Post-mortem analysis of graphite samples exposed to far scrape-off layer plasma fluxes during boron injection confirm the formation of a B-C layer, with average surface composition B:C ∼ 1. The results suggest that injecting boron-rich powders in tokamak plasmas can effectively replenish boron films on carbon plasma facing components to improve wall conditions and extend the duration of the beneficial effects of GDB.