A direct numerical simulation was carried out of plane turbulent Couette flow at a Reynolds number of 750, based on half the velocity difference between the walls and half the channel width. Particular attention was paid to choosing a computational box that is large enough to accommodate even the largest scales of the turbulence. In the central region of the channel very large elongated structures were observed, in accordance with earlier findings. The study is focused on the properties of these structures, but is also aimed at obtaining accurate turbulence statistics. Terms in the energy budget were evaluated and discussed. Also, the limiting values of various quantities were determined and their relevance in high Reynolds number flows discussed. The large structures were shown to be very sensitive to an imposed system rotation. They could be essentially eliminated with a stabilizing system rotation (around the spanwise axis) small enough for only minor damping of the rest of the scales. Despite the fact that the large structures dominate the appearance of the flow field their energy content was shown to be relatively small, on the order of 10% of the total turbulent kinetic energy.

Reynolds stress budgets for both Couette and boundary layer flows are evaluated and presented. Data are taken from direct numerical simulations of rotating and non-rotating plane turbulent Couette flow and turbulent boundary layer with and without adverse pressure gradient. Comparison of the total shear stress for the two types of flows suggests that the Couette case may be regarded as the high Reynolds number limit for the boundary layer flow close to the wall. The limit values of turbulence statistics close to the wall for the boundary layer for increasing Reynolds number approach the corresponding Couette flow values. The direction of rotation is chosen so that it has a stabilizing effect, whereas the adverse pressure gradient is destabilizing. The pressure-strain rate tensor in the Couette flow case is presented for a split into slow, rapid and Stokes terms. Most of the influence from rotation is located to the region close to the wall, and both the slow and rapid parts are affected. The anisotropy for the boundary layer decreases for higher Reynolds number, reflecting the larger separation of scales, and becomes close to that for Couette flow. The adverse pressure gradient has a strong weakening effect on the anisotropy. All of the data presented here are available on the web [36].